The EPIC focal plane imaging spectrometers on XMM-Newton use CCDs to record the images and spectra of celestial X-ray sources focused by the three X-ray mirrors. There is one camera at the focus of each mirror; two of the cameras contain seven MOS CCDs, while the third uses twelve PN CCDs, defining a circular field of view of 30′ diameter in each case. The CCDs were specially developed for EPIC, and combine high quality imaging with spectral resolution close to the Fano limit. A filter wheel carrying three kinds of X-ray transparent light blocking filter, a fully closed, and a fully open position, is fitted to each EPIC instrument. The CCDs are cooled passively and are under full closed loop thermal control. A radio-active source is fitted for internal calibration. Data are processed on-board to save telemetry by removing cosmic ray tracks, and generating X-ray event files; a variety of different instrument modes are available to increase the dynamic range of the instrument and to enable fast timing. The instruments were calibrated using laboratory X-ray beams, and synchrotron generated monochromatic X-ray beams before launch; in-orbit calibration makes use of a variety of celestial X-ray targets. The current calibration is better than 10% over the entire energy range of 0.2 to 10 keV. All three instruments survived launch and are performing nominally in orbit. In particular full field-of-view coverage is available, all electronic modes work, and the energy resolution is close to pre-launch values. Radiation damage is well within pre-launch predictions and does not yet impact on the energy resolution. The scientific results from EPIC amply fulfil pre-launch expectations.
High-time-resolution X-ray observations of compact objects provide direct access to strong-field gravity, to the equation of state of ultradense matter and to black hole masses and spins. A 10 m2-class instrument in combination with good spectral resolution is required to exploit the relevant diagnostics and answer two of the fundamental questions of the European Space Agency (ESA) Cosmic Vision Theme “Matter under extreme conditions”, namely: does matter orbiting close to the event horizon follow the predictions of general relativity? What is the equation of state of matter in neutron stars? The Large Observatory For X-ray Timing (LOFT), selected by ESA as one of the four Cosmic Vision M3 candidate missions to undergo an assessment phase, will revolutionise the study of collapsed objects in our galaxy and of the brightest supermassive black holes in active galactic nuclei. Thanks to an innovative design and the development of large-area monolithic silicon drift detectors, the Large Area Detector (LAD) on board LOFT will achieve an effective area of ~12 m2 (more than an order of magnitude larger than any spaceborne predecessor) in the 2–30 keV range (up to 50 keV in expanded mode), yet still fits a conventional platform and small/medium-class launcher. With this large area and a spectral resolution of <260 eV, LOFT will yield unprecedented information on strongly curved spacetimes and matter under extreme conditions of pressure and magnetic field strength.
The potential energy hidden in water resources is becoming more and more a significant economic value. The value of the hydroelectric energy is often magnified by the proximity of the turbine to pumps or other energy sinks owned by the same water manager. Cross-flow or Banki-Michel turbines are a very efficient and economic choice that allows a very good cost/benefit ratio for energy production located at the end of conduits carrying water from a water source to a tank. In the paper the optimum design of a cross-flow turbine is sought after, assuming a flow rate variable in time.Regulation of the discharge entering in the turbine is a key issue, which is faced adopting a shaped semicircular segment, moved inside the main case around the rotating impeller. The maximum efficiency of the turbine is attained by setting the velocity of the particles entering the impeller at about twice the velocity of the rotating system at the impeller inlet. If energy losses along the pipe are negligible, closing and opening the inlet surface with the semicircular segment allows always a constant hydraulic head and a constant velocity at the impeller inlet, even with different flow rate entering values. Observed reduction of the turbine efficiency along with the inlet surface reduction is first investigated; a design methodology, using also CFD simulations, is then proposed; finally, the same methodology is applied to a real site in Sicily, selected in the context of the HYDROENERGY P.O. - F.E.S.R. European project
The high resolution camera (HRC) is a microchannel plate based imaging detector for the Advanced X-Ray Astrophysics Facility (AXAF) that will be placed in a high earth orbit scheduled for launch in August, 1998. An end-to-end calibration of the HRC and the AXAF high resolution mirror assembly (HRMA) was carried out at the Marshall Space Flight Center's X-Ray Calibration Facility (XRCF). This activity was followed by several modifications to the HRC to improve its performance, and a series of flat field calibrations. In this paper, and the following companion papers, we discuss the calibration plans, sequences, and results of these tests. At the time of this conference, the HRC has been fully flight qualified and is being integrated into the science instrument module (SIM) in preparation for integration into the AXAF spacecraft.
The LOFT mission concept is one of four candidates selected by ESA for the M3 launch opportunity as Medium Size missions of the Cosmic Vision programme. The launch window is currently planned for between 2022 and 2024. LOFT is designed to exploit the diagnostics of rapid X-ray flux and spectral variability that directly probe the motion of matter down to distances very close to black holes and neutron stars, as well as the physical state of ultradense matter. These primary science goals will be addressed by a payload composed of a Large Area Detector (LAD) and a Wide Field Monitor (WFM). The LAD is a collimated (<1 degree field of view) experiment operating in the energy range 2-50 keV, with a 10 m2 peak effective area and an energy resolution of 260 eV at 6 keV. The WFM will operate in the same energy range as the LAD, enabling simultaneous monitoring of a few-steradian wide field of view, with an angular resolution of <5 arcmin. The LAD and WFM experiments will allow us to investigate variability from submillisecond QPO’s to yearlong transient outbursts. In this paper we report the current status of the project.