The aim of the research described in this paper, is to make a virtual thermal manikin that would be simple, but also robust and reliable. The virtual thermal manikin was made in order to investigate thermal conditions inside vehicle cabins. The main parameters of the presented numerical model that were investigated in this paper are mesh characteristics and turbulence models. Heat fluxes on the manikin's body segments obtained from the simulations were compared with published results, from three different experiments done on physical thermal manikins. The presented virtual thermal manikin, meshed with surface elements of 0.035 m in nominal size (around 13,600 surface elements) and in conjunction with the two-layer RANS Realizable k-? turbulence model, had generally good agreement with experimental data in both forced and natural flow conditions.

The aim of this paper is to derive an equation for the temperature distribution in journal bearing oil film, in order to predict the thermal load of a bearing. This is very important for the prevention of critical regimes in a bearing operation. To achieve the goal, a partial differential equation of the temperature field was first derived, starting from the energy equation coupled with the Reynolds equation of hydrodynamic lubrication for a short bearing of symmetric geometry. Then, by solving the equation analytically, the function of temperature distribution in the bearing oil film has been obtained. The solution is applied to the journal bearing, for which the experimental data are available in the references. Finally, the obtained results have been compared to the corresponding experimental values for two operating regimes, and a good level of agreement was achieved.

The subject of this paper is modeling of an intake manifold of a four-stroke IC engine using contemporary software tools. Virtual 3D CAD model of an intake manifold was designed based on a real intake manifold of a four-stroke IC engine. Based on the CAD model a 3D CFD model of the intake manifold was created. The modeling has been done with the purpose of simulation of the air flow inside the intake manifold in order to monitor values of the internal pressure during several seconds of the engine operation in three different operating points. Also, an experiment was conducted, which included measurements of intake manifold pressure in the same engine operating points in the course of a time interval of approximately the same duration. The results of both the simulation and the experimental measurements have been shown in the paper proving that the created model was good enough for the intended purpose.

Suspension system of a vehicle is one of the most important components of a vehicle that directly affects the safety, performance, noise level. Designing mechanisms of suspension system of the vehicle is a very complex task. At the...