Sheng Tan

Dr. Sheng Tan


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 May 2018 in Energies
Verified
Journal Article
Open access
PDF file
YOYang Ou
Yang Ou
JWJianjun Wu
Jianjun Wu
YZYu Zhang
Yu Zhang
JLJian Li
Jian Li
STSheng Tan
Sheng Tan
In this paper, a new numerical modeling method that combines a modified electromechanical model with a Teflon ablation model is proposed to simulate the working process of micro-pulsed plasma thruster (μPPT). The ablation mass accumulation during the discharge process and the non-Fourier effect during the ablation process are considered to improve simulation accuracy. Simulation results are in good agreement with experimental results. Furthermore, the influence of both the electrical and structural parts on the performance of μPPT was investigated by applying the combined model. It was proven that large capacitance of the capacitor and large gap-to-plate-width ratios can effectively improve the comprehensive performance of the thruster concluding the specific impulse, impulse bit, and efficiency. The results not only validate the theoretical model, but also guide the design and operation optimization of μPPT.

1 January 2019 in Acta Physica Sinica
Verified
Journal Article
Closed access
PDF file
STSheng Tan
Sheng Tan
JWJian-Jun Wu
Jian-Jun Wu
QHQiang Huang
Qiang Huang
YZYu Zhang
Yu Zhang
XDXin-Ru Du
Xin-Ru Du
Femtosecond laser ablation possesses a variety of applications due to its better control, high power density, smaller heat-affected zone, minimal collateral material damage, lower ablation thresholds, and excellent mechanical properties. The non-Fourier effect in heat conduction becomes significant when the heating time becomes extremely small. In order to analyze the femtosecond laser ablation process, a hyperbolic heat conduction model is established based on the dual-phase-lag model. Taken into account in the model are the effect of heat source, laser heating of the target, the evaporation and phase explosion of the target material, the formation and expansion of the plasma plume, and interaction of the plasma plume with the incoming laser. Temperature-dependent optical and thermophysical properties are also considered in the model due to the fact that the properties of the target will change over a wide range in the femtosecond laser ablation process. The effects of the plasma shielding, the ratio of the two delay times, and laser fluence are discussed and the effectiveness of the model is verified by comparing the simulation results with the experimental results. The results show that the plasma shielding has a great influence on the femtosecond laser ablation process, especially when the laser fluence is high. The ratio between the two delay times (the ratio B) has a great influence on the temperature characteristic and ablation characteristic in the femtosecond laser ablation process. The augment of the ratio B will increase the degree of thermal diffusion, which will lower down the surface temperature and accelerate the ablation rate after the ablation has begun. The ablation mechanism of femtosecond laser ablation is dominated by phase explosion. The heat affected zone of femtosecond laser ablation is small, and the heat affected zone is less affected by laser fluence. The comparison between the simulation results and the experimental results in the literature shows that the model based on the dual-phase-lag model can effectively simulate the femtosecond laser ablation process.