The influence of the method used for synthesizing ZnO-In2O3 composites (nanopowder mixing, impregnation, and hydrothermal method) on the structure, conductivity, and sensor properties is investigated. With the nanopowder mixing, the size of the parent nanoparticles in the composite remains practically unchanged in the range of 50–100 nm. The impregnation composites consist of 70 nm In2O3 nanoparticles with ZnO nanoclusters < 30 nm in size located on its surface. The nanoparticles in the hydrothermal composites have a narrow size distribution in the range of 10–20 nm. The specific surface of hydrothermal samples is five times higher than that of impregnated samples. The sensor response of the impregnated composite to 1100 ppm H2 is 1.3–1.5 times higher than the response of the mixed composite. Additives of 15–20 and 85 wt.% ZnO to mixed and impregnated composites lead to an increase in the response compared with pure In2O3. In the case of hydrothermal composite, up to 20 wt.% ZnO addition leads to a decrease in response, but 65 wt.% ZnO addition increases response by almost two times compared with pure In2O3. The sensor activity of a hydrothermal composite depends on the phase composition of In2O3. The maximum efficiency is reached for the composite containing cubic In2O3 and the minimum for rhombohedral In2O3. An explanation is provided for the observed effects.
Cu-doped In2O3 nanocomposites with copper compositions of 1–3 wt.% are synthesized by a hydrothermal method using water or alcohol as a solvent. Cubic In2O3 is formed when water is used for synthesis, while composites synthesized in alcohol contain rhombohedral In2O3. This trend is independent of the amount of copper introduced. The Cu ions are shown to be uniformly distributed in the In2O3 nanoparticles without significant destruction of the indium oxide structure. All the composites exhibit a porous structure that depends on the solvent used for the synthesis. The addition of copper to both crystalline forms of indium oxide increases the resistance of the films and reduces the operating temperature. The phase state of indium oxide also affects the conductivity of the composites. There is an increase in sensory response to H2 and CO with the introduction of Cu into samples with cubic structure, but a reduction in response in samples with the rhombohedral phase of indium oxide.
In2O3 nanoparticles were obtained by annealing precursors that had been hydrothermally/solvothermally synthesized at 200 °C using In(NO3)3·4.5H2O as the starting material. Three solvents were used for the synthesis, namely water, alcohol and ethylene glycol. Urea or glycine additives were introduced into the reaction mixtures as stabilizing and structure-forming agents. The nanopowders obtained were characterized using X-ray diffraction, scanning and transmission electron microscopy, low-temperature nitrogen adsorption and X-ray photoelectron spectroscopy. The gas-sensing characteristics of the indium oxide-based sensors were investigated for the detection of hydrogen in air. It has been established that the nature of the solvent determines the phase composition and structure of indium oxide, while organic additives reduce the particle size and increase the specific surface area. It should be noted that the addition of glycine to an alcohol solution of indium nitrate during synthesis produces a phase transformation. The results show that the sensor based on In2O3 synthesized using this mixture has the best hydrogen sensing properties of all the materials considered in this study.