In this study, a mathematical model for the supersonic condensate flow of natural gas to understand its condensation process in a supersonic separator has been proposed. The effects of export back pressure, inlet temperature, and inlet pressure on the condensation parameters were investigated. The results indicate that the condensation position moves forward with the increase in the inlet pressure and the decrease in the inlet temperature. A method for determining the optimal range of operating parameters (export back pressure, inlet temperature, and inlet pressure) for the supersonic separator is proposed. Within the optimal back pressure range, the region of extreme Mach number in the device should be at the inlet of the straight pipe section after the separation gap, and extreme value distribution areas of low temperature, condensation nucleation, and humidity should be between the nozzle expansion section and the inlet of the straight pipe section. It is important to choose a higher temperature among the optimal values as the inlet temperature and also ensure that the optimal inlet pressure is not higher than the pressure corresponding to the humidity inflection point. At the optimal inlet pressure, the maximum humidity distribution area should be behind the supersonic nozzle expansion section and in front of the inlet of the straight pipe section.
The S oilfield has adopted polymer flooding technology, specifically using partially hydrolyzed polyacrylamide (HPAM), to enhance oil recovery. During the production process, the S oilfield has generated a substantial amount of stable polymer flooding-produced liquid, in which oil droplets are difficult to effectively coalesce, presenting significant challenges in demulsification. This article focuses on the produced fluids from S Oilfield as the research subject, developing a molecular dynamics model for the stability analysis of production liquid, including the molecular dynamics model of an oil–pure water system, an oil–mineralized water system and an oil–polymer–mineralized water system, using the principle of molecular dynamics and combining it with the basic molecular model for analyzing the stability of polymer flooding-production liquid. Through the molecular dynamics simulation of the stability analysis of the extracted liquid, the changing rules of the molecular diffusion coefficient, radial distribution function (RDF), interfacial interaction energy, and interfacial tension under the action of ions as well as polymers in water were investigated. The simulation results demonstrate that the presence of all three inorganic salt ions (Na+, Ca2+, and Mg2+) reduces the interfacial tension between oil and water and stabilizes the interface. Following the addition of polymer, the interfacial tension of the system decreases and the interfacial interaction energy increases significantly, indicating that the stability of the system is significantly enhanced by HPAM.
Oil and gas mixing-transportation technology has been widely used in onshore and offshore petroleum system. A number of known simulation models apply only to the specific pipeline network form. A simulation model adopted for all forms of network is proposed for operation prediction of the oil-water and gas-liquid flow pipelines. For an accurate simulation of network with different configurations to get the pressure, flow rate and temperature, five existing viscosity models are evaluated. A combined model of emulsion viscosity is developed based on experimental data. Finally, the reliability of this simulation model has been examined. It is shown that the results of predictions are in acceptable agreement with production data indicating the capability of the model with combined model for simulating the multiphase flow pipeline network system.