Unlike a general commercial building, heating for a building with an indoor swimming pool is highly energy-intensive due to the high energy demand for swimming water heating. In Korea, the conventional heating method for this kind of building is to use boilers and heat storage tanks that have high fuel costs and greenhouse gas emissions. In this study, a combined heat and power (CHP) system for such a building using the electricity and waste heat from a Phosphoric Acid Fuel Cell (PAFC) system was designed and analyzed in terms of its primary energy saving, CO2 reduction, fuel cell and CHP efficiency, and economic feasibility. The mathematical model of the thermal load evaluation was used with the 3D multi-zone building model in TRNSYS 18 software (Thermal Energy System Specialists, LLC, Madison, MI, USA) to determine the space heating demand and swimming pool heat losses. The energy efficiency of the fuel cell unit was evaluated as a function of the part-load ratio from the operating data. The fundamental components, such as the auxiliary boiler, thermal storage tank, and heat exchanger are also integrated for the simulation of the system’s operation. The result shows that the system has a high potential to improve the utilization efficiency of fuel cell energy production. Referring to the local condition of the energy market in Korea, an economic analysis was also carried out by using a specific FC-CHP capacity at 440 kW. The economic benefit is significant in comparison with a conventional heating system, especially for the full-time operating (FTO) mode. The net profit made by comparison with the conventional energy supply system is about 178,352 to 273,879 USD per year, and the payback period is expected to be 6.9 to 10.7 years under different market conditions.
Recently, there has been growing recognition of the significance of energy and environmental challenges. Utilization of lithium-ion batteries in electric vehicles has shown considerable potential and benefits for tackling these issues. The effective management of battery temperature has become a crucial factor in the advancement and widespread adoption of lithium-ion batteries in electric vehicles. In this study, a thermo-coupled pseudo-two-dimensional (P2D) electrochemical model is employed to simulate the heat generation of the NCM811-21700 cylindrical battery cell at various discharge rates at an ambient temperature of 25 °C, and is validated by experimental data. The validation results demonstrate that the thermo-coupled P2D model can effectively predict the battery voltage curve during the discharge process with less than 4% errors. Although there is a slightly larger error in the temperature prediction during the battery 2C and 3C discharge processes, the maximum error approaches 10%, which is still generally within an acceptable range. In addition, the battery’s electrochemical and thermal characteristics during discharge are presented. The suggested thermo-coupled electrochemical model can be used for applications in the thermal management system of the NCM811-21700 battery.
9 September 2024 in International Journal of Heat and Mass Transfer
In this study, experiments were performed to use the waste heat in a billet casting industry utilizing bismuth telluride thermoelectric generators (TEGs). Four d-type absorber plates made of copper were installed above the manufactured billet during the cooling process. Three sides of each absorber plate were attached to thermoelectric units. Therefore, a total of 12 units of the thermoelectric system were found to generate a power of 339 W. The power density of the TEG system was found to be 981 W/m2 while running the system at the operating voltage of the battery energy storage system (58 V). A one-dimensional numerical simulation was carried out using FloMASTERTM v9.1 (Mentor Graphics Corporation, Siemens, Dallas, TX, USA) to verify the experimental results, and the numerical results were found to exhibit good agreement with the experimental results. Furthermore, a one-dimensional numerical simulation was carried out to obtain the heat transfer characteristics at varying flow rates of cold water (Reynolds number = 2540–16,943) and at different inlet temperatures (10–25 °C) for the cold side of the TEG. The results indicate that the performance of the thermoelectric generator increases with an increase in the cold-water flow rate and a decrease in the inlet temperature of the cold water.