The influence of the front facet reflectivity on the spectral linewidth of high power DFB (distributed feedback) diode lasers emitting at 780 nm has been investigated theoretically and experimentally. Characterization of lasers at various front facet reflections showed substantial reduction of the linewidth. This behavior is in reasonable agreement with simulation results. A minimum linewidth of 8 kHz was achieved at an output power of 85 mW with the laser featuring a front facet reflectivity of 30%. The device with a front facet reflectivity of 5% reached the same linewidth value at an output power of 290 mW.

We have proposed a fruitful design principle targeting a concentration ratio (CR) >1000× for a typical high concentrating photovoltaics (HCPV) system, on account of a two-concentrator system + homogenizer. The principle of a primary dual-lens concentrator unit, completely analogous basic optics seen in the superposition compound eyes, is a trend not hitherto reported for solar concentrators to our knowledge. Such a concentrator unit, consisting of two aspherical lenses, can be applied to minify the sunlight and reveal useful effects. We underline that, at this stage, the CR can be attained by two orders of magnitude simply by varying the radius ratio of such two lenses known from the optics side. The output beam is spatially minimized and nearly parallel, exactly as occurs in the superposition compound eye. In our scheme, thanks to such an array of dual-lens design, a sequence of equidistant focal points is formed. The secondary concentrator consists of a multi-reflective channel, which can collect all concentrated beams from the primary concentrator to a small area where a solar cell is placed. The secondary concentrator is located right underneath the primary concentrator. The optical characteristics are substantiated by optical simulations that confirm the applicability of thousands-fold gain in CR value, ~1100×. This, however, also reduced the uniformity of the illumination area. To regain the uniformity, we devise a fully new homogenizer, hinging on the scattering principle. A calculated optical efficiency for the entire system is ~75%. Experimentally, a prototype of such a dual-lens concentrator is implemented to evaluate the converging features. As a final note, we mention that the approach may be extended to implement an even higher CR, be it simply by taking an extra concentrator unit. With simple design of the concentrator part, which may allow the fabrication process by modeling method and large acceptant angle (0.6°), we assess its large potential as part of a general strategy to implement a highly efficient CPV system, with minimal critical elaboration steps and large flexibility.

Polymer-based micro-optical components are very important for applications in optical communication. In this study, we theoretically investigated the coupling of polymeric waveguide and microring structures and experimentally demonstrated an efficient fabrication method to realize these structures on demand. First, the structures were designed and simulated using the FDTD method. The optical mode and loss in the coupling structures were calculated, thereby giving the optimal distance for optical mode coupling between two rib waveguide structures or for optical mode coupling in a microring resonance structure. Simulations results then guided us in the fabrication of the desired ring resonance microstructures using a robust and flexible direct laser writing technique. The entire optical system was thus designed and manufactured on a flat base plate so that it could be easily integrated in optical circuits.

This study evaluated the effects of different LED spectral irradiance ratios on the growth, secondary metabolites, and essential oil characteristics of Ocimum × africanum Lour. cultivated for four weeks under controlled conditions. Four LED lighting treatments with different red, blue, green, ultraviolet-A, and far-red light ratios, and a treatment in greenhouse as low-light control were used. The constant 16 h photoperiod and light intensity of 220 µmol·m⁻²·s⁻¹ were maintained. The F2 treatment (UV-A:B:R:Fr = 6.60:45.15:29.23:19.02) promoted the greatest plant height (76.62 cm), and chlorophyll a (7.41 mg/100 g, FW), chlorophyll b (4.73 mg/100 g, FW), and total phenolic (25.78 mg/g, FW) concentrations. F1 treatment (B:G:R:Fr = 17.14:29.8:47.4:5.66) produced significantly higher (p < 0.01) biomass (8.3 ton/ha, FW), oil yield (10.89 L/ha), and carotenoid (3.74 mg/100 g, FW) than the others. Essential oils contained 12–15 compounds, dominated by neral (27.5–37.3%), geranial (41.1–49.9%), and (E)-β-caryophyllene (2.4–9.9%), while the highest contents of oil (0.83%, DW), anthocyanin (16.50 mg/100 g, FW), and total flavonoid (14.17 mg/g, FW) were obtained under F4 (B:G:R:Fr = 13.85:43.50:39.30:3.35). These findings demonstrate that optimized LED spectra can effectively improve both productivity and phytochemical quality in O. africanum through regulating both primary and secondary metabolism.

Agricultural land is increasingly under pressure from expanding solar energy infrastructure, leading to a growing conflict between food and energy production. Conventional photovoltaic (PV) systems often reduce crop yields due to shading and suboptimal light conditions for photosynthesis. This study introduces a Red Spectrum Splitting Concentrated Agrivoltaic (RSSCA) system designed to overcome these limitations by selectively directing specific wavelengths of sunlight to serve both agricultural and energy needs. The system uses a Fresnel lens and dichroic mirror to concentrate solar radiation and split the spectrum: red light (around 630 nm), essential for rice growth, is transmitted to the crops, while the remaining wavelengths are directed to high-efficiency multi-junction solar cells. We employed optical simulations and analytical modeling to assess system performance. Results show a photoelectric conversion efficiency of 31.2% and adequate Daily Light Integral (DLI) levels for rice cultivation in high-sunlight regions such as Hanoi and Ho Chi Minh City. For instance, DLI values in Hanoi range from 14.3 to 32.2 mol/m²/day and in Ho Chi Minh City from 24.3 to 37.8 mol/m²/day, compared to 6.6–16.1 and 14.4–18.2 mol/m²/day under conventional PV systems, respectively. Electricity production with RSSCA peaks at 2790 W/m²/day in Ho Chi Minh City and 2577 W/m²/day in Hanoi, outperforming traditional PV setups by 3–5 times. Compared to conventional PV systems, the RSSCA offers improved light uniformity, better land-use efficiency, and significantly higher electricity generation. However, in regions with limited direct sunlight, such as Seoul in winter, system performance decreases. These findings suggest the RSSCA system is well-suited for tropical and subtropical areas where direct sunlight is abundant. It presents a viable solution for enhancing both food production and renewable energy generation on shared land.