We have applied the nearly perfectly matched layer (N-PML) absorber to the viscoelastic wave equation based on the Kelvin-Voigt and Zener constitutive equations. In the first case, the stress-strain relation has the advantage of not requiring additional physical field (memory) variables, whereas the Zener model is more adapted to describe the behavior of rocks subject to wave propagation in the whole frequency range. In both cases, eight N-PML artificial memory variables are required in the absorbing strips. The modeling simulates 2D waves by using two different approaches to compute the spatial derivatives, generating different artifacts from the boundaries, namely, 16th-order finite differences, where reflections from the boundaries are expected, and the staggered Fourier pseudospectral method, where wraparound occurs. The time stepping in both cases is a staggered second-order finite-difference scheme. Numerical experiments demonstrate that the N-PML has a similar performance as in the lossless case. Comparisons with other approaches (S-PML and C-PML) are carried out for several models, which indicate the advantages and drawbacks of the N-PML absorber in the anelastic case.
This study examines the potential of phosphogypsum—a by-product of the phosphoric acid production process—as a low-cost and sustainable adsorbent for the removal of crystal violet dye from aqueous solutions. Phosphogypsum was characterized using X-ray fluorescence, X-ray diffraction, particle size distribution, and zeta potential measurements, revealing that it is primarily composed of di-hydrate calcium sulfate, with a negatively charged surface in the pH range from 1.8 to 8.2 and a mean particle size of 12.2 microns. Experiments were conducted to evaluate the effects of pH, adsorbent dose, contact time, and temperature on its adsorption ability. The results indicated that the adsorption capacity increased with the pH up to a value of 5, while higher initial dye concentrations enhanced the uptake capacity but reduced the removal efficiency. The adsorption process was well described by the Langmuir isotherm, suggesting chemisorption as the dominant mechanism, while the pseudo-second-order kinetic model indicated that adsorption primarily occurred on the exterior surface. The thermodynamic analysis revealed that the process was exothermic and spontaneous at 20 °C and 30 °C, with a decrease in favorability at higher temperatures. The adsorbent demonstrated reusability, with a removal efficiency of 71% after five regeneration cycles. Furthermore, phosphogypsum was successfully applied to treat real textile effluent, achieving significant reductions in both biochemical oxygen demand (71%) and dye content (87%). These findings highlight the potential of phosphogypsum as an effective and eco-friendly adsorbent for wastewater treatment, contributing to waste valorization and environmental sustainability.
19 March 2014 in Journal of Petroleum Exploration and Production Technology
We simulate two-phase fluid flow using a stress–strain relation based on Biot’s theory of poroelasticity for partial saturation combined with the mass conservation equations. To uncouple flow and elastic strain, we use a correction to the stiffness of the medium under conditions of uniaxial strain. The pressure and saturation differential equations are then solved with an explicit time stepping scheme and the Fourier pseudospectral method to compute the spatial derivatives. We assume an initial pressure state and at each time step compute the wetting- and non wetting-fluid pressures at a given saturation. Then, we solve Richards’s equation for the non wetting-fluid saturation and proceed to the next time step with the updated saturations values. The pressure and saturation equations are first solved separately and the results compared to known analytical solutions showing the accuracy of the algorithm. Then, the coupled system is solved. In all the cases, the non-wetting fluid is injected at a given point in space as a boundary condition and capillarity effects are taken into account. The examples consider oil injection in a water-saturated porous medium.