Despite the strength and ductility of steel reinforcing bars, their susceptibility to corrosion can limit the long-term durability of reinforced concrete structures. Fiber-reinforced polymer (FRP) reinforcing bars made with a thermosetting matrix offer corrosion resistance but cannot be field-bent, which limits flexibility during construction. FRP reinforcing bars made with fiber-reinforced thermoplastic polymers (FRTP) address this limitation; however, their high processing viscosity presents manufacturing challenges. In this study, the Continuous Forming Machine, a novel pultrusion device that uses pre-consolidated fiber-reinforced thermoplastic tapes as feedstock, is described and used to fabricate 12.7 mm nominal diameter thermoplastic composite rebars. Simple bend tests on FRTP rebar that rely on basic equipment are performed to verify its ability to be field-formed. The manual bending technique demonstrated here is practical and straightforward, although it does result in some fiber misalignment. Subsequently, surface deformations are introduced to the rebar to promote mechanical bonding with concrete, and tensile tests of the bars are conducted to determine their mechanical properties. Finally, flexural tests of simply-supported, 6 m long beams reinforced with FRTP rebar are performed to assess their strength and stiffness as well as the practicality of using FRTP rebar. The beam tests demonstrated the prototype FRTP rebar’s potential for reinforcing concrete beams, and the beam load–deformation response and capacity agree well with predictions developed using conventional structural analysis principles. Overall, the results of the research reported indicate that thermoplastic rebars manufactured via the Continuous Forming Machine are a promising alternative to both steel and conventional thermoset composite rebar. However, both the beam and tension test results indicate that improvements in material properties, especially elastic modulus, are necessary to meet the requirements of current FRP rebar specifications.
Large Area Additive Manufacturing (LAAM) enables the rapid production of thermoplastic polymer structures but suffers from significant anisotropy and 3D printability limitations. These limitations often require additional material and time in order to incorporate supporting structures. This research explores the integration of continuous fiber reinforced thermoplastics (CFRTP) with LAAM structures. A series of experimental trials were performed, which demonstrate the feasibility and benefits of CFRTP integration, as it can improve structural strength, lightweighting, and manufacturing flexibility. The findings suggest that CFRTP integration can significantly enhance LAAM by reducing material usage, improving mechanical properties, and expanding design possibilities. While further research is needed to optimize the process for specific applications, this process of Hybrid Advanced Additive Manufacturing (HAAM) presents a promising approach for advancing large-scale additive manufacturing.
A method is proposed to locally heat areas of thick (>25.4 mm) continuous glass fiber reinforced thermoplastic (C-FRTP) composites with embedded wire mesh resistive heating elements. Four test specimens including 10.6 cm wide nichrome mesh heating elements embedded in C-FRTP laminates were fabricated and used for heating trials, showing that the composite can be locally heated to near the thermoplastic forming temperature over its entire thickness in less than 1 hour. The heating trials were simulated using a purpose-built finite difference model to investigate detailed temperature distributions. The simulations show that the internal resistive heating elements are capable of locally increasing the temperature of the composite with negligible effect on the adjacent material. Heating efficiency is between 73% and 77%, with temperature differences in the z-direction at peak temperatures less than 35°C. Temperature uniformity can be improved by longer heating times and more heating elements. The local heating method does not cause deconsolidation of the part. The heating method was also experimentally assessed on a more complex cross-section laminate with varying thickness and a foam core using stainless steel mesh heating elements. Results from the first heating tests were applied to the experimental assessment of the more complex laminate to reduce z-direction temperature differences. Numerical simulation of the heating of the foam core laminate showed a z-direction temperature range of 15.5°C. The results of this study show that embedded resistive heating is a cost-effective and simple method for heating a local portion of a thick fiber reinforced thermoplastic composite.