Despite the strength and ductility of steel reinforcing bars, their susceptibility to corrosion can limit the long-term durability of reinforced concrete structures. Fiber-reinforced polymer (FRP) reinforcing bars made with a thermosetting matrix offer corrosion resistance but cannot be field-bent, which limits flexibility during construction. FRP reinforcing bars made with fiber-reinforced thermoplastic polymers (FRTP) address this limitation; however, their high processing viscosity presents manufacturing challenges. In this study, the Continuous Forming Machine, a novel pultrusion device that uses pre-consolidated fiber-reinforced thermoplastic tapes as feedstock, is described and used to fabricate 12.7 mm nominal diameter thermoplastic composite rebars. Simple bend tests on FRTP rebar that rely on basic equipment are performed to verify its ability to be field-formed. The manual bending technique demonstrated here is practical and straightforward, although it does result in some fiber misalignment. Subsequently, surface deformations are introduced to the rebar to promote mechanical bonding with concrete, and tensile tests of the bars are conducted to determine their mechanical properties. Finally, flexural tests of simply-supported, 6 m long beams reinforced with FRTP rebar are performed to assess their strength and stiffness as well as the practicality of using FRTP rebar. The beam tests demonstrated the prototype FRTP rebar’s potential for reinforcing concrete beams, and the beam load–deformation response and capacity agree well with predictions developed using conventional structural analysis principles. Overall, the results of the research reported indicate that thermoplastic rebars manufactured via the Continuous Forming Machine are a promising alternative to both steel and conventional thermoset composite rebar. However, both the beam and tension test results indicate that improvements in material properties, especially elastic modulus, are necessary to meet the requirements of current FRP rebar specifications.
Large Area Additive Manufacturing (LAAM) enables the rapid production of thermoplastic polymer structures but suffers from significant anisotropy and 3D printability limitations. These limitations often require additional material and time in order to incorporate supporting structures. This research explores the integration of continuous fiber reinforced thermoplastics (CFRTP) with LAAM structures. A series of experimental trials were performed, which demonstrate the feasibility and benefits of CFRTP integration, as it can improve structural strength, lightweighting, and manufacturing flexibility. The findings suggest that CFRTP integration can significantly enhance LAAM by reducing material usage, improving mechanical properties, and expanding design possibilities. While further research is needed to optimize the process for specific applications, this process of Hybrid Advanced Additive Manufacturing (HAAM) presents a promising approach for advancing large-scale additive manufacturing.