The effect of epoxidized soybean oil on the operational, technological, and physical and mechanical properties of composites based on high-density recycled polyethylene filled with wood floor was investigated. It has been shown that the introduction of epoxidized soybean oil in the amount of 0.5 wt.% into the wood-polymer composite (WPC) improves the physical, mechanical, and operational properties of the material: the Charpy impact strength (on notched samples) increases from 7.5 kJ/m² to 20.0 kJ/m², the bending strength increases from 31.6 MPa to 50.8 MPa, and the coefficient of linear thermal expansion decreases by 15%. With a further increase in the content of epoxidized soybean oil in the composite, its water absorption and technological shrinkage decrease, but its physical and mechanical properties deteriorate.

It has been experimentally confirmed that polyethylene terephthalate during its processing into products destruct without carrying out the process of solid-phase polycondensation. The conditions for both primary and secondary polyethylene terephthalate have been determined for carrying out the process of solid-phase polycondensation for its effective reaction extrusion with chain extenders. To confirm the effectiveness of the parameters of the solid-phase polycondensation process of polyethylene terephthalate, its reaction extrusion was carried out with commercially available chain extenders of the diepoxide class. The optimal content of chain extenders of the diepoxide class for changing the complex of physical, mechanical and rheological properties of polyethylene terephthalate modified by them was determined. It allows obtaining materials with an increased by 2.2 times characteristic viscosity.

Low-viscosity epoxy-containing diluents are used to reduce the initial viscosity of highly filled, wear-resistant epoxy systems and to improve filler wetting and dispersion. This study determined physical parameters by an atomic-increment approach and electronic descriptors using the Parametric Method 3 (PM3) semi-empirical method. Clear relationships were established between the effective molar cohesion energy and the solubility parameter with van der Waals volume. Linear dependencies were also obtained between the diluent surface tension and spreading coefficients on model high-hardness fillers, including silicon carbide, boron carbide, and normal corundum. The activity of epoxy diluents depends on the lowest unoccupied molecular orbital energy. These diluents influence processing and the final physical and mechanical properties of composites, making their selection critical for strength, hardness, and wear resistance. Computational analysis enables prediction of diluent behavior, reducing experimental time and cost. Integrating physical and quantum-chemical data into epoxy diluent design accelerates the search for optimal components and improves production of durable, high-performance epoxy composites.

In the manuscript the main factors that affect the thermal mass of open and closed types of heat storage devices are shown. Also, the main requirements for adsorption modules are given. The calculation procedure has been refined, which includes the determination of heat load, heat of adsorption, adsorbent mass, as well as integral, structural, and specific thermal mass. The specific thermal masses of adsorption heat-accumulating modules of open and closed types were evaluated. The main factors affecting their value are analysed. It is shown that the specific thermal mass of the adsorption heat storage module increases significantly due to the adsorption of water during the discharge of the device. It is shown that it reaches its maximum values at the end of the discharge stage, when the maximum values of adsorption in the cycle are reached. The influence of the design of the heat storage module on the value of the specific thermal mass has been confirmed. It is shown that the maximum values of these changes correspond to the composites containing 80% salt and 20% silica gel, due to the maximum values of the limiting adsorption and the heat of adsorption, which contributes to the lower values of the adsorbent mass, which is required to cover the thermal load. Specific thermal masses of adsorption modules based on "silica gel - sodium sulphate" and "silica gel - sodium acetate" composites are compared. The composition of the composite is 80% sodium sulphate and 20% silica gel, which corresponds to the minimum dimensions of the adsorption module, and therefore the maximum value of the specific thermal mass.