António E Ribeiro

Dr. António E Ribeiro

orcid

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 August 2022 in Micromachines
Verified
Journal Article
Open access
PDF file
IAInês Santos Afonso
Inês Santos Afonso
JPJosé Pereira
José Pereira
ARAntónio E Ribeiro
António E Ribeiro
Joana AmaralJoana Amaral
Joana Amaral
Nuno RodriguesNuno Rodrigues
Nuno Rodrigues
João RibeiroJoão Ribeiro
João Ribeiro
In this work, we carried out a comparison between the dry machining of an aluminum block with conventional cutting oil and a block with vegetable oil. The two oils had different flow rates. Using the Taguchi method, it was possible to determine the matrices for optimizing the best parameters for each group of tests. Then, we studied the utility of using vegetable oil as a cutting lubricant. We found that the vegetable oil studied in this work had good properties in terms of reducing cutting temperatures but was less effective than conventional cutting oil in reducing the surface roughness of the machined part. Tribological tests were carried out to understand the influence of the selected lubricants in reducing friction and wear. After the sliding experiments, which were performed without lubrication in the presence of the same lubricants that were used in the machining tests and in the presence of distilled water, we concluded that vegetable oil has satisfactory lubricating properties that are similar to those of the conventional cutting fluid, indicating a potential for consideration as an effective alternative to the conventional cutting fluid, with economic, environmental, and health advantages.


1 September 2025 in Clean Technologies
Verified
Journal Article
Open access
PDF file
IAInês Santos Afonso
Inês Santos Afonso
CDCristina Duarte
Cristina Duarte
MAMaria João Almeida Pinto dos Santos Afonso
Maria João Almeida Pinto dos Santos Afonso
ARAntónio E Ribeiro
António E Ribeiro
Joana AmaralJoana Amaral
Joana Amaral
João RibeiroJoão Ribeiro
João Ribeiro
Olive mill wastewaters (OMWW) generated during olive oil extraction represent a significant environmental challenge due to their high organic matter content, acidic pH, phenolic content, and toxicity. Their composition varies widely depending on the extraction method and remains difficult to treat, particularly for small-scale producers lacking access to complex infrastructure. This study evaluates the combined effect of the extraction system (traditional vs. three-phase continuous) and filtration level (single vs. double) on the physicochemical and biological properties of OMWW. The methodologies employed included the analysis of water content, density, fatty acid composition, acidity, pH, total solids, chemical and biochemical oxygen demand, and biodegradability. The results indicate that traditional systems consistently produced OMWW with higher organic matter and phenolic loads, while filtration moderately reduced antioxidant potential and acidity, especially in traditional systems. The use of simple, low-cost filtration materials proved effective in improving effluent clarity and could serve as a practical pre-treatment option. This approach offers an accessible strategy for small producers aiming to valorise OMWW or reduce environmental impact. However, the study was conducted at the laboratory scale, and the long-term behaviour of filtered OMWW under real operating conditions remains to be evaluated.

4 May 2023
Verified
Book Chapter
Closed access
PDF file
IAInês Santos Afonso
Inês Santos Afonso
CDCristina Nogueira Duarte
Cristina Nogueira Duarte
ARAntónio E Ribeiro
António E Ribeiro
Joana AmaralJoana Amaral
Joana Amaral
João RibeiroJoão Ribeiro
João Ribeiro

27 December 2022
Verified
Conference Paper
Closed access
AQAna Queiroz
Ana Queiroz
VRVinicius A. Reis
Vinicius A. Reis
Jose Luis Diaz de TuestaJose Luis Diaz de Tuesta
Jose Luis Diaz de Tuesta
PBPaulo Brito
Paulo Brito
ARAntónio E Ribeiro
António E Ribeiro
Adsorption is a treatment process based on accumulation of the adsorbate (pollutant) on the adsorbent surface that has been successful used for the optimization of wastewater treatment plant effluents cleaning. This work will present the main experimental results for the removal of naproxen from water by adsorption using activated carbon obtained from olive stones. Four types of activated carbon material were prepared from olive stones. The batch method was applied to experimentally measure the equilibrium adsorption isotherms. The most significant adsorption parameters were optimized, such as the solution pH, mass of the adsorbent, contact time and temperature. The physicochemical characterization of the pyrolyzed material shows a considerable superficial area of 608 m2/g when compared with other natural biomass-based materials. A removal efficiency of 100% was obtained for 24 h and a pH=4.5. The Langmuir model was used to better describe the adsorption behavior for adsorbent with better removal performance with the highest maximum adsorption capacity value of 35.2 mg naproxen/g adsorbent. The kinetics of the adsorption is well described by a pseudo-second order model. Obtained results in this work clearly show that olive stones, usually a residue from the Portuguese and Mediterranean oliviculture, can be exploited as a promising and lowcost biomass source on the production of adsorbent materials with considerable potential to remove micropollutants, such as the naproxen, from water.

27 December 2022
Verified
Conference Paper
Closed access
AQAna Queiroz
Ana Queiroz
PBPaulo Brito
Paulo Brito
ARAntónio E Ribeiro
António E Ribeiro
ECEduardo V. Carneiro
Eduardo V. Carneiro
NFNathalia S. Foureaux
Nathalia S. Foureaux