Enio Deus

Dr. Enio Deus


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 June 2025 in Chemosensors
Verified
Journal Article
Open access
PDF file
Antonio J. M. SalesAntonio J. M. Sales
Antonio J. M. Sales
Stephen Rathinaraj BenjaminStephen Rathinaraj Benjamin
Stephen Rathinaraj Benjamin
João NascimentoJoão Nascimento
João Nascimento
FCFelipe Felix Do Carmo
Felipe Felix Do Carmo
JSJuscelino Chaves Sales
Juscelino Chaves Sales
ASAntonio Sergio Sombra
Antonio Sergio Sombra
Hydrogen is gaining prominence as a clean energy vector, yet its extreme flammability demands robust detection solutions for industrial safety. In this study, we present the development and experimental validation of a microwave hydrogen gas sensor based on a patch-type microstrip antenna with a silver sensing element. The device operates at 5.99 GHz and was tested under controlled environmental conditions (humidity: 20 ± 0.4%, temperature: 27 ± 0.2 °C). Hydrogen exposure induces measurable shifts in the antenna’s resonant frequency due to dielectric modulation of the silver layer. The sensor exhibited a linear sensitivity of 3 kHz/ppm in the 310–600 ppm concentration range, with a residual standard deviation of 31.1 kHz and a calculated limit of detection (LOD) of approximately 31 ppm. The reflection coefficient remained below −10 dB throughout, confirming that the antenna maintains functional RF performance during sensing. These results demonstrate the sensor’s dual functionality for gas detection and communication, offering a compact and scalable platform for hydrogen safety monitoring.

5 June 2023 in Journal of Building Pathology and Rehabilitation
Verified
Journal Article
Closed access
PDF file
AGArthur Gomes
Arthur Gomes
AOAudelis Oliveira
Audelis Oliveira
João Vitor da Silveira NunesJoão Vitor da Silveira Nunes
João Vitor da Silveira Nunes
EDEnio Deus
Enio Deus

6 January 2026 in REVISTA DELOS
Verified
Journal Article
Open access
PDF file
CRCassius Olivio Figueiredo Terra Ruchert
Cassius Olivio Figueiredo Terra Ruchert
MCMárcio Corrêa Carvalho
Márcio Corrêa Carvalho
EDEnio Deus
Enio Deus
MMMarcos Fábio Veríssimo Montezuma
Marcos Fábio Veríssimo Montezuma
JMJoão Victor Silva Mendes
João Victor Silva Mendes
Dimensional stability in austempering ductile iron (ADI) rotor shafts is critical in compressor manufacturing. This study evaluated the influence of two austempering heat treatments, standard (N) and modified (A), on the dimensional variation of the shafts. The fraction of retained austenite was quantified by image analysis. Treatment (A) resulted in a fraction of retained austenite greater than 10%, versus 5% of treatment (N). Thermal tests at 170 °C showed no dimensional variation, but at 210 °C, the samples (A) expanded markedly. This behavior is due to the transformation of metastable austenite above the martensitic onset temperature (Ms), determined between 170-210 °C. It is concluded that strict control of austempering is essential to ensure dimensional stability, preventing the formation of thermally unstable austenite.

11 March 2021
Verified
Book Chapter
Closed access
PDF file
KMK. M. V. Moreira
K. M. V. Moreira
FRFrancisco Roger Carneiro Ribeiro
Francisco Roger Carneiro Ribeiro
EDEnio Deus
Enio Deus
ACAntonio Eduardo Bezerra Cabral
Antonio Eduardo Bezerra Cabral

18 September 2026 in Preprints.org
Verified
Preprint
Open access
PDF file
SMSantino Loruan Silvestre Melo
Santino Loruan Silvestre Melo
EDEnio Deus
Enio Deus
Chitosan is an appealing matrix for low-cost separator membranes in water electrolysis, but fillers are normally screened one at a time and judged on mechanical grounds, so the way a filler simultaneously reshapes hydration and ionic transport is rarely mapped across a single consistent series. We cast seven membranes from chitosan extracted in-house from Litopenaeus vannamei shells — pristine chitosan and composites containing graphite (1 wt.%), bamboo cellulose nanocrystals (1 and 3 wt.%), graphene oxide (1 and 3 wt.%) and a ternary 1 wt.% NCC/1 wt.% GO formulation — and characterised all of them by proximate analysis, DSC, electrolyte uptake in 1 wt.% KOH, uniaxial tension, Shore D hardness, a five-cycle ultrasonic ageing protocol and polarisation in a purpose-built two-compartment cell. The two filler families moved hydration and transport in opposite directions. Nanocellulose raised the moisture content from 11.00% to 13.46% while lowering the conductivity of the casting dispersion by 12.5% and 23.2% at 1 and 3 wt.%; graphene oxide cut moisture to 6.42% and raised dispersion conductivity by 18.4% and 25.9%. Across the series the two quantities were inversely correlated (r = −0.761, p = 0.047). Electrolysis onset potential tracked dispersion conductivity (Spearman ρ = −0.857, p = 0.014) but showed no relationship with tensile strength (p = 0.125), so the functional gain from a filler is not predictable from the mechanical data alone. Loadings above 1 wt.% degraded every property measured, and the 3 wt.% GO membrane was the only composite to fail the ageing protocol. Filler selection for these membranes is therefore a compromise, not an optimisation.