The civil Global Navigation Satellite System (GNSS) signal is broadcast with an open structure, making it vulnerable to spoofing attacks. Incorporating authentication data into GNSS signals is a significant measure to enhance system security. Precise Point Positioning (PPP) technology has garnered extensive attention for its ability to provide real-time services with centimeter-level accuracy. The PPP service features a high data update rate, with the validity period of the data being approximately ten to twenty seconds. This imposes more stringent requirements on the authentication data rate and the authentication time. Code Shift Keying (CSK) technology has emerged as a key candidate for satellite-based PPP signal design, as it can increase the data rate without requiring additional spectrum resources. This paper investigates authentication methods for CSK-modulated satellite-based PPP signals. Two approaches are proposed: phase modulation authentication and polarity modulation authentication. Simulation and analysis results indicate that the PPP signal with phase modulation authentication experiences less carrier-to-noise ratio (C/N0) loss and has a higher detection probability. In contrast, the signal with polarity modulation authentication does not suffer from C/N0 loss and achieves a higher data rate and a shorter authentication time. These findings can serve as valuable references for future GNSS signal design.
Precise point positioning (PPP) technology has garnered extensive attention for its ability to deliver real‐time centimetre‐level accuracy services. When providing PPP services via satellite navigation signals, it is necessary to increase the data rate to over 1000 bps. Code shift keying (CSK) technology has emerged as a key candidate for satellite‐based PPP signal design. It can increase the data rate without requiring additional frequency resources and compromising ranging performance. However, CSK technology faces several challenges. Firstly, it is vulnerable to multipath interference, which can lead to intersymbol interference. Secondly, the complexity of demodulation increases exponentially with an increase in the number of bits per symbol. In this paper, a novel approach for the design and reception of CSK signals with a phase interval mapping of power‐of‐two chips is proposed. Analyses demonstrate that this method is capable of significantly reducing the demodulation complexity while mitigating the intersymbol interference. The CSK (6, 2) modulation with a phase interval mapping of 128 chips is employed for the BDS PPP‐B2b signal. The signal is demodulated using the FFT with a phase interval output of 128 points. The computation can be reduced by approximately 85%, compared to the continuous phase mapping CSK signal demodulated by partial‐output FFT.