An autonomous remote clock control system is proposed to provide time synchronization and frequency syntonization for satellite to satellite or ground to satellite time transfer, with the system comprising on-board voltage controlled oven controlled crystal oscillators (VC-OCXOs) that are disciplined to a remote master atomic clock or oscillator. The synchronization loop aims to provide autonomous operation over extended periods, be widely applicable to a variety of scenarios and robust. A new architecture comprising the use of frequency division duplex (FDD), synchronous time division (STDD) duplex and code division multiple access (CDMA) with a centralized topology is employed. This new design utilizes dual one-way ranging methods to precisely measure the clock error, adopts least square (LS) methods to predict the clock error and employs a third-order phase lock loop (PLL) to generate the voltage control signal. A general functional model for this system is proposed and the error sources and delays that affect the time synchronization are discussed. Related algorithms for estimating and correcting these errors are also proposed. The performance of the proposed system is simulated and guidance for selecting the clock is provided.
With L band frequency allocations for satellite navigation getting more crowded, S band (2483.5–2500 MHz) is already allocated for navigation services, where Globalstar broadcasts downlink communications to user terminals. The Indian Regional Navigation Satellite System (IRNSS) is transmitting navigation signals and Galileo exploits some potential signals in S band. Also, several candidate S band signals based on binary offset carrier (BOC), binary phase shift keying (BPSK), continuous phase modulation (CPM) and minimum shift keying-BOC (MSK-BOC) are suggested for BeiDou system (BDS). In quite narrow S band, mutual interference among these systems is inevitable, thus the compatibility issue is particularly significant for S band signal design. To explore desired S band signals for BDS, the paper firstly describes a comprehensive compatibility evaluation methods based on effective carrier-to-noise ratio degradation for acquisition and code tracking. Then a real simulation is established using space constellations, modulation schemes and received power. Finally, the worst mutual interference of BDS candidate signals with Galileo, IRNSS and Globalstar is calculated and compared. The results indicate that CPM signal is easier to allow peaceful coexistence of other systems with minimal mutual interference in S band compared to other BDS candidates.
Using the Doppler frequency obtained from tracking a GNSS pilot signal to aid in tracking another signal modulated with higher rate navigation messages in a different frequency band can improve tacking robustness and lower the message demodulation threshold. Based on an analysis of received signal frequency coherence, a linearized mathematical model of the cross-frequency Doppler-assisted carrier phase tracking loop is built, a thermal noise jitter calculation equation for the assisted tracking loop is derived, and its dynamic stress response characteristics are examined. The loop design requirements for eliminating the influence of inter-frequency frequency bias are clarified, as are the cross-frequency assist signal selection criteria. Monte Carlo simulations and preliminary field tests validate the theoretical results using the B1C pilot signal-aided tracking B2b signal of the MEO satellite in the BeiDou satellite navigation system (BDS). Experimental results show that the carrier phase tracking threshold of the B2b signal can be reduced by about 4 dB.
The civil Global Navigation Satellite System (GNSS) signal is broadcast with an open structure, making it vulnerable to spoofing attacks. Incorporating authentication data into GNSS signals is a significant measure to enhance system security. Precise Point Positioning (PPP) technology has garnered extensive attention for its ability to provide real-time services with centimeter-level accuracy. The PPP service features a high data update rate, with the validity period of the data being approximately ten to twenty seconds. This imposes more stringent requirements on the authentication data rate and the authentication time. Code Shift Keying (CSK) technology has emerged as a key candidate for satellite-based PPP signal design, as it can increase the data rate without requiring additional spectrum resources. This paper investigates authentication methods for CSK-modulated satellite-based PPP signals. Two approaches are proposed: phase modulation authentication and polarity modulation authentication. Simulation and analysis results indicate that the PPP signal with phase modulation authentication experiences less carrier-to-noise ratio (C/N0) loss and has a higher detection probability. In contrast, the signal with polarity modulation authentication does not suffer from C/N0 loss and achieves a higher data rate and a shorter authentication time. These findings can serve as valuable references for future GNSS signal design.