Groundwater pollution is regarded as one of the most serious environmental risks related to underground coal gasification (UCG). In this paper, two kinds of high efficient phenol degrading strains were isolated from activated sludges, which were obtained from coking wastewater and domestic sewage, and were named as JC and WX correspondingly. The isolated bacteria were identified by a combination method of physiological and biochemical analyses and 16SrDNA sequencing. The total organic carbon (TOC) and organic pollutants in gas washing water produced from the UCG model test of lignite were measured by TOC analyzer and gas chromatography‐mass spectrometer (GC‐MS), and the microbial degradation effect of gas washing water was finally studied by the isolated bacteria. The results reveal that JC and WX bacteria were pseudomonas aeruginosa and achromobacter xylosoxidans, respectively, and that phenolic compounds were the main organic pollutants in gas washing water, taking 95.01 percent of the total organics. The removal of TOC exceeded 72.9%, the degradation efficiency of total organic pollutants (TOM) achieved 79.03% and the degradation efficiency of phenolic compounds could be 98.76% by JC and 99.04% by WX, respectively. Most benzene series (BTEX) could not be degraded by the screened two kinds of bacteria, whereas the concentrations of BETX were increased. Some short‐chain hydrocarbon compounds with low concentrations were also detected in wastewater after microbial degradation.
The development of coal-based activated carbon for supercapacitors provides a robust and effective approach toward the clean and efficient use of coal, and it also offers high-quality and low-cost raw materials for energy storage devices. However, the one-step activation method for preparing coal-based activated carbon has problems, such as difficulty in introducing surface-functional groups and high KOH dosage. In our work, activated carbon was prepared through an effective strategy of oxidation and KOH activation with a low KOH content by employing coal-based carbon dots as raw material. The influence of temperature during the KOH activation of carbon dots on a specific surface area, pore structure, and various quantities and types of surface-functional groups, as well as on the electrochemical performance of supercapacitors, was systematically studied. The as-prepared sample, with the alkali–carbon ratio of 0.75, processes a large specific surface area (1207 m2 g−1) and abundant surface-functional groups, which may provide enormous active sites and high wettability, thus bringing in high specific capacitance and boosted electrochemical performances. The oxygen and nitrogen content of the activated carbon decreases while the carbon content increases, and the activation temperature also increases. The as-prepared activated carbon reaches the highest specific capacitance of 202.2 F g−1 in a 6 M KOH electrolyte at a current density of 10 A g−1. This study provides new insight into the design of high-performance activated carbon and new avenues for the application of coal-based carbon dots.
We have demonstrated a compact, 4.7 W green laser based on an electrically pumped vertical external-cavity surface emitting laser through intracavity frequency doubling. The overall wall-plug efficiency (electrical to green) was 18.3%. The power fluctuations were measured to be over a 2 h time period.
To construct a highly active g-C3N4 (CN)/silica hybrid nanosystem, the supramolecular precursor strategy of introducing melamine–cyanuric acid (MCA) by synergistically using micromolecular melamine (m) and urea (u) for CN nanostructure construction on the silica nanosheets (SiNSs) surface was researched. The results showed that the introduction of MCA supramolecular aggregates promoted the generation of ordered CN nanostructures attached to SiNSs, and the morphology of the CN nanostructure could be regulated through the m/u mass ratio. When the ratio is equal to 1/30, a typical g-C3N4/silica hybrid nanosheet (mu-CN/SiNSs-3) was successfully prepared, which showed the ultra-high photocatalytic activity for Rhodamine B dye degradation within 25 min with an apparent rate constant of 0.186 min−1, owing to the large surface area of highly dispersed and ordered CN nanosheets, a strong interaction between CN and SiNSs, high photogenerated carriers separation efficiency, and the more negative conduction band potential offering more active species of 1O2 and •O2−. Unexpectedly, the mu-CN/SiNSs-2 composite (m/u = 1/10) exhibited the highest activity for tetracycline antibiotic degradation, mainly due to the morphological advantage of a certain number of nanotubes generated on the CN/SiNSs hybrid nanosheets. It indicates that the supramolecular precursor strategy by synergistically using melamine and urea is highly efficient for the nanostructure construction of the CN/SiNSs hybrid system, enabling an appropriate nanostructure for the photodegradation of various pollutants.