In soft soil or karst areas, several problems exist, such as the poor properties of the pile tip bearing layer or difficulties in cutting the rock. Using multi-tooth piles, end-bearing piles can be turned into friction piles to solve these problems. Through the scale model device, three variables: the bearing layer, tooth length, and tooth number, are designed to experimentally explore the load-bearing behaviour of multi-tooth piles under different bearing layer conditions. The test results show that the model pile has better anti-settlement performance in the sand bearing layer than in the red clay bearing layer. Compared with smooth piles, multi-tooth piles can greatly improve the bearing capacity of pile foundations in bearing layers with poor stiffness. The tooth length and tooth number greatly impact the compressive bearing capacity and the pile-side resistance of the multi-tooth pile, respectively. The concept of roughness is innovatively introduced to quantify the roughness of pile surfaces, which provides an effective method for the subsequent experimental and theoretical research of multi-tooth piles and other similar piles with small cross-section modifications. This study can enrich the research field of small, modified cross-section piles and provide a reference for innovative research on pile foundations.
A new type of thorn pile is proposed to address the poor bearing capacity of the foundation. The design of five thorn piles is presented, and the numerical simulation of pile–soil interaction under a uniform silt foundation is performed using ABAQUS software. The influence of thorn shape on the compressive bearing capacity of thorn piles is elucidated, and the mechanism of thorn structure on the soil around piles is analyzed. The results showed that the thorn pile can significantly increase pile shaft resistance and reduce pile top settlement compared with the smooth pile. The ultimate bearing capacity of the 5# pile is 1.6 times higher than that of the smooth pile, while the pile top settlement is reduced by 82.9%. The addition of a thorn structure effectively changes the mechanical characteristics of pile shaft resistance softening. Due to the unique characteristic of the divergent conical surface, the truncated conical thorns exert a powerful radial pressure on the surrounding soil under load, thereby increasing the effective stress of the soil around the pile, expanding the influence range of the soil around the pile, and fully mobilizing the shear resistance of the soil, thus improving the bearing capacity of the foundation pile. The optimal shape of the taper thorn is a cone under the same conditions of length and volume. The research results can provide a theoretical foundation for the design and construction of the thorn pile.
18 December 2017 in IOP Conference Series: Earth and Environmental Science
Combining literature examples, this paper has carried out Contrastive analysis of the theoretical formula method and finite element method about the ultimate bearing capacity of foundation, To verify rationality and superiority of the incremental load method in finite element ABAQUS in solving the bearing capacity of foundation soil. The study can provide certain reference for practical engineering calculation and analysis of foundation bearing capacity.
1 June 2020 in IOP Conference Series: Earth and Environmental Science
The detection of pile top elevation is a key link of pile quality control. Based on the jacking principle, this paper analyzes the shortcomings of the existing measurement methods, innovatively introduces the pore pressure to consider the influence of the change of slurry level, effectively proposes an improved pressure detection method, and designs a pressure detection device. The device is simple and easy to operate, which can provide reference for the field research on the elevation of the top of bored pile.