The combination of electrocoagulation (EC) with complementary treatment methods has garnered increasing attention for wastewater remediation. This study aims to design and optimize a hybrid electrocoagulation–adsorption (EC/Ads) process for the removal of ketoprofen (KTP) from aqueous solutions. The adsorption of KTP onto activated carbon (AC) alone exhibited a low removal efficiency of approximately 27% under the following conditions: initial KTP concentration ([KTP]0) = 23 mg·L−1, pH = 6, adsorbent dose (qAC) = 0.5 g, and contact time = 30 min. In contrast, the EC process alone achieved a removal efficiency of 59.69% under similar conditions (current density (i) = 18.6 mA·cm−2, NaCl = 3.5 g·L−1). The combined EC/Ads process significantly enhanced KTP removal, reaching 87.11% under the same operational parameters. The synergistic effect of the combined treatment was quantified with a synergy index of 1.37. Characterization techniques included FTIR analysis of both AC and KTP, as well as adsorption–desorption isotherms and pHPZC determination for AC. To further optimize the EC/Ads process, a response surface methodology based on central composite design (CCD) was applied to assess the influence of four independent variables: pH, [KTP]0, current density, and qAC. Optimal conditions were identified as follows: qAC = 0.63–0.99 g, i = 12.32–14.68 mA·cm−2, pH = 6.5, and [KTP]0 = 22.5 mg·L−1; these conditions resulted in 100% KTP removal after 30 min of treatment. These findings demonstrate the potential of the EC/Ads hybrid process to be an efficient and sustainable alternative for pharmaceutical contaminant removal.
Water availability and quality represent a major challenge facing water scarcity and pollution. The United Nations Organization predicts that 44% of the world population will live a severe water scarcity, in 2050. Countries located in sub-humid and semi-arid regions of the world will be especially concerned by this problematic. Water disinfection by Ultraviolet (UV) radiation is a rising technique in water treatments considering its simplicity and the weak risk of toxic byproducts formation. When UV radiation is absorbed by the cells of microorganisms, it damages the genetic material (DNA) within the cell in such a way that the organisms are no longer able to grow or reproduce, thus preventing the human illness cryptosporidiosis. DNA damage mainly results from irradiation at wavelengths within the UV-C region of the spectrum (200-280 nm) and is maximised at around 254 nm. This is the principle by which UV is used for disinfection. Time required to achieve a total disinfection depends both on the quality of water and the intensity of irradiation. Effective disinfection can be provided by a suitable intensity and duration of UV radiation to give a UV \"dose\" usually expressed in mJ/cm2 (= mW second/cm2, the product of UV intensity in mW/cm2 and contact time in seconds). The target dose will depend on the application, but a dose of 40 mJ/cm2 is commonly used for UV disinfection systems, validated for the broad spectrum inactivation of possible waterborne pathogens such as bacteria, viruses and protozoan parasites such as Cryptosporidium. The objective of this study is to present the state of art of different methods of intensity measurement and modeling, and the use of MPSS model to evaluate the UV intensity distribution inside the photoreactor.