Recently a two-dimensional chiral fluid was experimentally demonstrated. It was obtained from cubic-shaped hematite colloidal particles placed in a rotating magnetic field. Here we look at building blocks of that fluid by analyzing short hematite chain behavior in a rotating magnetic field. We find equilibrium structures of chains in static magnetic fields and observe chain dynamics in rotating magnetic fields. We find and experimentally verify that there are three planar motion regimes and one where the cube chain goes out of the plane of the rotating magnetic field. In this regime we observe interesting dynamics—the chain rotates slower than the rotating magnetic field. In order to catch up with the magnetic field, it rolls on an edge and through rotation in the third dimension catches up with the magnetic field. The same dynamics is also observable for a single cube when gravitational effects are explicitly taken into account.
Co-axial electrospinning is one of the facile methods for the fabrication of core–shell metal oxides for environmental applications. Indeed, core–shell architectures featuring a magnetic core and a photocatalytic shell represent a novel approach to catalytic nanostructures in applications such as water treatment and pollutant removal via magnetic separation. This study focuses on the fabrication of novel Fe3O4-Fe2NiO4/NiO core–shell nanofibers with enhanced optical and magnetic properties using co-axial electrospinning. The aim is to optimize the fabrication parameters, particularly the amount of metal precursor in the starting solutions, to achieve well-defined core and shell structures (rather than single-phase spinels), and to investigate phase transitions, structural characteristics, as well as the optical and magnetic properties of the resulting nanofibers. Raman, XRD, and XPS results show several phases and high defect concentration in the NiO shell. The Fe3O4-Fe2NiO4/NiO core–shell nanofibers exhibit strong visible-light absorption and significant magnetization. These advanced properties highlight their potential in photocatalytic applications.
In the present study analysis of co-firing microwave (MW) pre-treated biomass pellets of different origins (wood and wheat straw), with raw pellets (wood, straw, and peat), to control and improve thermochemical conversion of biomass blends and achieve a sustainable use of local energy resources in energy production has been carried out. Effects of MW pre-treatment regimes and composition of blends were studied experimentally using measurements of the weight loss of blends, the yield of volatiles, flame temperature, total heat output from the device, and composition of products. It was found that co-firing MW pre-treated and raw biomass pellets promotes synergistic interaction between components of blends by increasing mass loss rate, the intensity of which depends on the proximate composition of pellets, MW pre-treatment regime and mass fraction of pre-treated pellets in the blend. The most effective synergistic interaction was found when co-firing pre-treated straw or wood pellets with raw peat, which increased the yield of combustible volatiles and heat output from the device as well as improved the composition of emissions. The least effective synergistic interaction was observed when co-firing pre-treated straw with raw wood pellets. Main factors that influenced the thermal and chemical conversion of MW pre-treated blends are discussed considering the effects of MW pre-treatment on the structural changes, elemental and chemical composition, and heating value of pre-treated pellets.
Creating a physiologically relevant shear stress in organ-on-a-chip (OOC) devices requires careful tailoring of microfluidic flow parameters. Currently, it is fairly common to use a simple approximation assuming constant viscosity, even for serum-based media. Here, we show that a popular nutrient solution (Dulbecco’s Modified Eagle Medium supplemented with Fetal Bovine Serum) requires a more complex treatment (i.e., is a non-Newtonian fluid), with observed shear stress values significantly greater than reported in literature. We measure the rheology of the solutions and combine it with a 3-dimensional flow field measurement to derive shear stress at the channel surface. We verify the experiments with numerical simulations, finding good agreement and deriving flow properties. Finally, we provide relevant expressions for the shear stress approximation, suitable for development of OOC devices with various geometries.