Many control schemes have been proposed for induction motors, which are in themselves highly complex non‐linear and sometimes internally unstable systems. One of the most accurate control schemes is encodered rotor flux orientated vector control. The advantages and disadvantages of this control are well known and several variations, or reduced vector schemes, have been proposed. This study introduces an improved encoderless scalar, or approximated vector, control method for induction machines which can be applied to general purpose applications that do not require the most precise control. The proposed method overcomes practical difficulties and is suitable for industrial applications. The slip compensated stator flux linkage oriented scheme proposed in this study does not require flux estimation or a speed sensor, only requiring nameplate data, stator current and stator resistance measurement, which can easily be determined at start‐up. Simulation and experimental investigations including field weakening operation and the effect of stator resistance variation demonstrate the improved performance of the new scheme compared to previous open loop V/Hz and stator resistive compensated schemes especially at low rotor speeds.
20 December 2022 in IEEE Transactions on Industrial Electronics
Modular battery energy storage systems (MBESSs) enable the use of lower-rated voltage converters and battery modules, and simpler battery management systems. They also improve the system's reliability and allow flexible power sharing among different modules. This article proposes a power-sharing algorithm that maximizes the energy conversion efficiency of this battery energy storage system, considering state of charge (SoC) balancing and battery lifespan. Real-time optimum power sharing is undertaken based on a simple lookup table, whose data were generated via offline genetic algorithm optimization considering the converter's efficiency map. To demonstrate the effectiveness of the proposed algorithm, a six-module prototype system was constructed, each comprising a half-bridge converter and a 10 Ah, 12.8 V, LiFePo4 battery. System testing occurred at different battery power levels in both charging and discharging modes, using the proposed efficiency-optimized power-sharing and the conventional SoC-based power-sharing methods. The results obtained show that the proposed power-sharing control significantly improves the light load efficiency compared to the conventional and equal power-sharing methods. At high loads, the proposed method gives a higher efficiency than the SoC-based method and an equivalent efficiency to the equal power-sharing method.
Modular converters offer an effective solution for battery energy storage systems (BESSs) by lowering battery pack voltage levels and enabling additional functionalities, such as state of charge (SoC) and state of health (SoH) balancing, temperature regulation, and improved system reliability. However, conventional modular designs often require numerous additional components, including passive elements, switches, and sensing circuits. This paper proposes a modular multi-port converter (MMPC) BESS that combines energy conversion and battery management functions, leveraging the benefits of both modular and multi-port architectures. The proposed system demonstrates promising scalability and adaptability within the tested voltage and power ranges, with potential for extension to higher voltage and power applications through modular expansion. It also introduces an additional control layer, enhancing flexibility for control optimization and cost-effectiveness while improving reliability by reducing dependency on bypass switches. A prototype utilizing three dual-port converters managing six battery packs was developed. The experimental results confirm that the MMPC-based BESS achieves energy conversion and effectively balances the SoC among battery packs during both charging and discharging, under initial SoC mismatches.