This study explores the sustainable synthesis and structural characterization of carbon, graphite, graphene oxide (GO), and reduced graphene oxide (rGO) derived from coconut shells. The objective is to investigate the potential of biomass-based precursors to produce functional carbon materials through controlled chemical treatments. X-ray diffraction patterns of carbon and graphite exhibit broad peaks, indicating low crystallinity and amorphous characteristics, while GO and rGO show dominant peaks at 22° and 23°, corresponding to the (002) plane. Scanning electron microscopy confirms the disordered morphology of carbon and graphite, while high-resolution transmission electron microscopy reveals wrinkled GO sheets and partially restacked rGO layers. Fourier transform infrared spectra identify O−H stretching at ~3442 cm−1 in carbon and C=C stretching at 1630 cm−1 in graphite, along with various oxygen-containing functional groups in GO and rGO. Raman spectroscopy shows a sharp G band at 1580 cm−1 in graphite (ID/IG = 0.840), increased disorder in GO (ID/IG = 0.843), and partial graphitic restoration in rGO (ID/IG = 0.841). These findings confirm the successful transformation of coconut shells into valuable carbon-based materials and highlight their potential for use in sustainable energy and electronic applications.
14 February 2023 in Journal of Superconductivity and Novel Magnetism
The shortage of tellurium and toxicity of lead are major obstacles to scaling mid-temperature thermoelectric generators. We engineer quaternary lead chalcogenides with composition (Pb0.8Ge0.2Te)0.95-x(PbSe)0.05(PbS)x (0 ≤ x ≤ 0.25), where Pb is lead, Ge is germanium, Te is tellurium, Se is selenium, S is sulfur, and x denotes the molar fraction of lead sulfide (PbS). The primary novelty lies in achieving ultra-low thermal conductivity through controlled phase segregation induced by systematic PbS incorporation. X-ray diffraction analysis reveals single-phase solid solutions up to x ≈ 0.10, with secondary PbS precipitates forming beyond this threshold. These PbS-rich phases create hierarchical microstructures that scatter phonons across multiple length scales, suppressing total thermal conductivity to 0.6 Wm−1K−1 at x = 0.15—approximately 84% lower than pristine lead telluride (PbTe) and approaching glass-like thermal conductivity values. Electrical transport measurements demonstrate sulfur’s role as an electron donor, enabling carrier-type control from p-type to n-type conduction. Despite moderate electrical power factors, the optimized composition (x = 0.20) achieves a peak dimensionless figure of merit ZT ≈ 0.34 at 650 K. This work demonstrates an effective strategy for tellurium-lean, lead-reduced thermoelectric materials through sulfur-induced phase segregation, providing practical design guidelines for sustainable waste heat recovery applications.
For this study, a modified barium hexaferrite based microwave and radar absorbing material was used. Synthesis and characterization of BaFe(12−2x)(MnTi)xO19 (0.1 ≤ x ≤ 1.0) have been prepared by solid state reaction method. The x-ray diffraction patterns reveal that all samples only crystallized into M-type barium hexaferrite after calcination at 1200 °C. Surface morphology images show that the hexagonal flake-like particle is formed at the initial stages of the Mn-Ti substitution level. The magnetic properties measurement reveals that the variation of magnetization values may vary based on preferable site occupation of Mn4+-Ti2+ cations to replace Fe3+ cations. The significant decrease in coercive field (Hc) from 3.18 kOe to 0.51 kOe with the increase of Mn-Ti substitution affected the lowering values of anisotropy field (Ha). The maximum reflection loss (RL) positions of BaFe(12−2x)(MnTi)xO19 compositional series are shifted to lower frequency range following the Ha trendlines. The maximum RL value equals to 98.42% microwave absorption at 10.5 GHz has been obtained in x = 1.0 (BaFe10Mn0.5Ti0.5O19) composition.
31 December 2025 in International Journal of Modern Physics B