Vertical axis turbines, also called Darrieus turbines, present interesting characteristics for offshore wind and tidal applications but suffer from vibrations and a lower efficiency than the more conventional horizontal axis turbines. The use of variable pitch, in order to control the angle of attack of the blades continuously during their rotation, is considered in this study to overcome these problems. 2D blade-resolved unsteady Reynolds-Averaged Navier–Stokes (RANS) simulations are employed to evaluate the performance improvement that pitching blades can bring to the optimal performance of a three-straight-blade vertical axis tidal turbine. Three pitching laws are defined and tested. They aim to reduce the angle of attack of the blades in the upstream half of the turbine. No pitching motion is used in the downstream half. The streamwise velocity, monitored at the center of the turbine, together with the measurement of the blades’ angle of attack help show the effectiveness of the proposed pitching laws. The decrease in the angle of attack in the upstream half of a revolution leads to a significant increase in the power coefficient () and to a better balance of the torque generated in the upstream and downstream halves. Both torque and thrust ripples are therefore significantly reduced.
The hydro-elastic response of a flexible NACA 0015 hydrofoil is investigated for both wetted and cavitating flow conditions. Computational fluid dynamics (CFD) analysis are performed using a fully implicit coupling between the ISIS-CFD solver (developed by the METHRIC team at Ecole Centrale de-Nantes) and a modal approach for the structure. The Reynolds-averaged Navier–Stokes (RANS) solver is first validated for wetted and cavitating flow conditions around a similar rigid hydrofoil, with experimental results carried out at the hydrodynamic tunnel of the French Naval Academy, including lift and drag measurements and high speed camera images. Then the numerical predictions for the flexible hydrofoil response are compared with experimental bending shapes and vibrations amplitudes, with a focus on cavitating flow conditions. For wetted flow conditions, numerical results show a good agreement with the experiments, for both rigid and flexible hydrofoils. For cavitating flow conditions, the hydro-elastic response is dominated by vibrations at the hydrofoil modal frequencies and the reentrant jet instability frequency. For the lowest values of the cavitation number, a large amplitude peak is experimentally observed in the frequency response spectra, due to lock-in between the first modal frequency and the reentrant jet frequency. Strong harmonics of this dominant peak also appear in the spectra, revealing a nonlinear response of the hydrofoil. While the amplitudes of vibrations are well predicted by the computations, the frequency lock-in observed in the experiments is not captured by the numerical model.
This paper deals with the development of a Matlab-Simulink model of a marine current turbine system through the modeling of the resource and the rotor. The purposes of the simulation model are two: performances and dynamic loads evaluation in different operating conditions and control system development for turbine operation based on pitch and speed control. In this case, it is necessary to find a compromise between the simulation model accuracy and the control loop computational speed. The blade element momentum (BEM) approach is then used for the turbine modeling. As the developed simulation model is intended to be used as a sizing and site evaluation tool for current turbine installations, it has been applied to evaluate the extractable power from the Raz de Sein (Brittany, France). Indeed, tidal current data from the Raz de Sein are used to run the simulation model over various flow regimes and yield the power capture with time.