Routine maintenance of fishing vessels and wastewater discharges are primary sources of heavy metals in fishing ports. Sediment pollution assessment is necessary in fishing port management, including sediment dredging and disposal, sewage treatment facility construction, and pollution source control. In this study, sediment heavy metal contents in Qianzhen Fishing Port, the largest pelagic fishery port in Taiwan, were investigated to assess the contamination levels and related potential ecological risks using multiple sediment pollution indices. Normalization methods were applied to identify the potential sources of heavy metals in fishing port sediments. Results showed that Cu, Zn, Pb, and Cr contents in the sediments of the inner fishing port (averages of 276, 742, 113, and 221 mg/kg, respectively) were 3–5 times greater compared to those along the port entrance and outside, indicating the strong impacts of anthropogenic pollution (EFCu: 5.6–12.5; EFZn: 2.8–4.3; EFPb: 2.4–5.4; EFCr: 1.1–3.2). Copper pollution was more severe, with high maxima contamination factor (CFCu: 15.1–24.8), probably contributed by copper-based antifouling paints used in fishing vessels. The sediments in the inner fishing port are categorized as having considerable ecological risk and toxicity (mERMq: 0.61–0.91; ΣTU: 7.5–11.7) that can potentially cause adverse effects on benthic organisms. Qianzhen Fishing Port sediments can be characterized as high Cu/Fe and Pb/Fe, moderate Zn/Fe, and high total grease content, indicating that the potential sources of heavy metals are primarily antifouling paints and oil spills from the fishing vessels. This study provides valuable data for pollution control, remediation, and environmental management of fishing ports.
The qualitative and quantitative analysis of 16 polycyclic aromatic hydrocarbons (PAHs) in sludge samples from drinking water treatment plants (DWTP) and wastewater treatment plants (WWTP) were established using gas chromatography–mass spectrometry (GC-MS). The method was suitable to quantify PAHs in the sludge of DWTP and WWTP and it was confirmed by the relevant quality assurance/quality control (QA/QC) procedures. The recovery of individual PAHs in the spiked samples ranged from 74.3% to 108.7%. Detection limits of the analytical procedure were 0.0010–0.0046 mg/kg dw for individual PAHs. This method was used to determine the concentration of PAHs in the selected two DWTP and four WWTP sludge samples. The results showed that the total PAHs (∑PAHs) were in low levels which ranged from 0.0668 to 0.1357 mg/kg dw, and 0.5342–1.0666 mg/kg dw for DWTP and WWTP respectively. The 3- & 4-ring PAHs were predominant in DWTP sludge, ranging from 77.4% to 82.7%; the 4-ring PAHs were predominant in WWTP sludge, ranging from 40.7% to 47.6%. The PAHs of DWTP sludge are mainly composed of 3-ring phenanthrene and anthracene and 4-ring pyrene, and chrysene. The PAHs of WWTP sludge are dominated by 4-ring fluoranthene, pyrene, and chrysene. The detected PAHs concentration should be undoubtedly considered for agriculture in sludge applications based on the limits of the EU regulations. The results of this study can be used for regular monitoring to establish a reference for sludge management and application to agriculture.