Routine maintenance of fishing vessels and wastewater discharges are primary sources of heavy metals in fishing ports. Sediment pollution assessment is necessary in fishing port management, including sediment dredging and disposal, sewage treatment facility construction, and pollution source control. In this study, sediment heavy metal contents in Qianzhen Fishing Port, the largest pelagic fishery port in Taiwan, were investigated to assess the contamination levels and related potential ecological risks using multiple sediment pollution indices. Normalization methods were applied to identify the potential sources of heavy metals in fishing port sediments. Results showed that Cu, Zn, Pb, and Cr contents in the sediments of the inner fishing port (averages of 276, 742, 113, and 221 mg/kg, respectively) were 3–5 times greater compared to those along the port entrance and outside, indicating the strong impacts of anthropogenic pollution (EFCu: 5.6–12.5; EFZn: 2.8–4.3; EFPb: 2.4–5.4; EFCr: 1.1–3.2). Copper pollution was more severe, with high maxima contamination factor (CFCu: 15.1–24.8), probably contributed by copper-based antifouling paints used in fishing vessels. The sediments in the inner fishing port are categorized as having considerable ecological risk and toxicity (mERMq: 0.61–0.91; ΣTU: 7.5–11.7) that can potentially cause adverse effects on benthic organisms. Qianzhen Fishing Port sediments can be characterized as high Cu/Fe and Pb/Fe, moderate Zn/Fe, and high total grease content, indicating that the potential sources of heavy metals are primarily antifouling paints and oil spills from the fishing vessels. This study provides valuable data for pollution control, remediation, and environmental management of fishing ports.
The qualitative and quantitative analysis of 16 polycyclic aromatic hydrocarbons (PAHs) in sludge samples from drinking water treatment plants (DWTP) and wastewater treatment plants (WWTP) were established using gas chromatography–mass spectrometry (GC-MS). The method was suitable to quantify PAHs in the sludge of DWTP and WWTP and it was confirmed by the relevant quality assurance/quality control (QA/QC) procedures. The recovery of individual PAHs in the spiked samples ranged from 74.3% to 108.7%. Detection limits of the analytical procedure were 0.0010–0.0046 mg/kg dw for individual PAHs. This method was used to determine the concentration of PAHs in the selected two DWTP and four WWTP sludge samples. The results showed that the total PAHs (∑PAHs) were in low levels which ranged from 0.0668 to 0.1357 mg/kg dw, and 0.5342–1.0666 mg/kg dw for DWTP and WWTP respectively. The 3- & 4-ring PAHs were predominant in DWTP sludge, ranging from 77.4% to 82.7%; the 4-ring PAHs were predominant in WWTP sludge, ranging from 40.7% to 47.6%. The PAHs of DWTP sludge are mainly composed of 3-ring phenanthrene and anthracene and 4-ring pyrene, and chrysene. The PAHs of WWTP sludge are dominated by 4-ring fluoranthene, pyrene, and chrysene. The detected PAHs concentration should be undoubtedly considered for agriculture in sludge applications based on the limits of the EU regulations. The results of this study can be used for regular monitoring to establish a reference for sludge management and application to agriculture.
The sediment pollution index acts as a useful indicator for assessing anthropogenic pollution within river drainage basins. An industrialized urban river, Fengshan River in Kaohsiung City, southern Taiwan has been suffering heavy metal pollution from surrounding factories. In this study, spatial and seasonal variations in heavy metals in sediments from seven sampling sites of Fengshan River were determined to assess sediment pollution status and potential ecological risk using multiple sediment pollution indices. Results showed that the heavy metal concentrations displayed large spatial variations. Severe contamination of heavy metals, especially for Cr, Hg, and Zn in the lower reaches of Fengshan River, may attribute to wastewater discharges from leather processing and metal finishing factories along the river drainage basin. An increase in metal concentrations from upstream to downstream indicated that heavy metals tend to accumulate in tidal reaches, probably as a result of the flocculation effect. Frequent heavy rainfall in the wet season can enhance surface runoff to discharge metal pollutants from non-point sources (scattered factories) into the river. Assessment of multiple pollution indices showed moderately polluted (mCd = 3.9, PLI = 2.6) and considerable ecological risk (RI = 540, mERMQ = 0.55), indicating Fengshan River sediments, particularly in the lower reaches, are considered toxic and can cause adverse effects to benthic organisms. Organic matters showed a good correlation with heavy metals, which play an important role in the spatiotemporal variations in heavy metal pollutants in the Fengshan River sediments. This study can provide valuable information for river pollution remediation, and urban planning and management.
This study investigated the concentrations of monobutyltin (MBT), dibutyltin (DBT) and tributyltin (TBT) in the sediments of the Qianzhen Fishing Port (Taiwan) in 2020. Further, the pollution status, composition, and potential ecotoxicity of BTs were evaluated. This case study provides a reference for the benefits of the ban of TBT-based antifouling paint to date. Results showed that the total butyltin (ΣBTs, sum of TBT, DBT, and MBT) concentrations measured in the sediments of the Qianzhen Fishing Port ranged between 14.2–807 ngSn·g−1 dw, with an average of 356 ± 305 ngSn·g−1 dw. TBT was the most dominant species, with an average concentration of 303 ± 287 ngSn·g−1 dw. This average TBT concentration is about 4.3 times lower than in 2003, showing the progress of gradual degradation of TBT in the sediments. Still, the degradation is rather slow, with a half-life of about 8.09 years. An analysis of the effects of TBT on organisms in the sediments of the Qianzhen Fishing Port was carried out according to the TBT toxicity guidelines of the US Environmental Protection Agency and the assessment class criterion for imposex (ACCI) of the Oslo and Paris Commission (OSPAR). The results showed that TBT levels in 80% of the sediments may pose negative effects on sensitive gastropods, and half of the sediments may even have an impact on gastropod reproduction. These show that marine life is still affected and threatened by TBT compounds, despite the decline of TBT concentrations since the ban of TBT-containing antifouling paints on ships in 2008. Therefore, it is necessary to continue paying attention to the changes of TBT concentrations and their potential ecological risks in the marine environment, and to formulate TBT management plans and strategies to mitigate their impacts in marine ecosystems.
This study investigated the spatial distribution of di-(2-ethylhexyl) phthalate (DEHP), and its potential biological effects, in the surface sediments that were collected from 10 sites at the Love River during dry and wet seasons. The grain size and organic matter were measured to understand the key factors that affect the distribution of DEHP concentrations in the sediments of Love River. The mean DEHP concentrations in the sediments that were collected during the wet and dry seasons were 28.6 ± 19.5 and 17.8 ± 11.6 mg/kg dry weight, respectively. The highest DEHP concentration was observed in the sediments that were sampled in the vicinity of the estuary. The correlation analysis showed that the grain size and organic matter may play a key role in the DEHP distribution in the sediments during the dry season, whereas the DEHP concentrations in the wet season may be mainly affected by other environmental and hydrological conditions. By a comparison with the sediment quality guidelines, the levels of DEHP in the sediments of Love River were found to have the potential to result in an adverse effect on aquatic benthic organisms. Specifically, during the wet season, wastewater from upstream of Love River is flushed downstream, causing a higher DEHP concentration in the sediments. Future pollution prevention and management objectives should move towards reducing the discharge of upstream wastewater and establishing a complete sewer system to reduce DEHP pollution in the environment.
A naval ship’s exhaust gas scrubber may discharge polycyclic aromatic hydrocarbons (PAHs) into seawater. Due to the high lipophilicity and low water solubility of PAHs, their concentrations in seawater are extremely low, making them difficult to detect or accurately determine. To accurately assess the impact of scrubber washwater effluent on the PAHs concentration of seawater, appropriate analysis methods must be established. In this study, a large-volume pre-concentration water sampler was used onboard to concentrate PAHs in surface seawater (100 L) from four sites offshore of southern Taiwan. The quantitative and qualitative analysis of dissolved PAHs in seawater and quality control samples were implemented using a GC/MS system with the aid of internal and surrogate standards. Results showed that the field and equipment blank samples of quality control samples were lower than twice the detection limit. The detection limit of individual PAHs is between 0.001 (naphthalene, NA) and 0.014 ng/L (dibenzo[a,h]anthracene, DBA), which meets the requirements for evaluating PAHs in seawater (that is, less than the maximum permissible concentrations (MPCs)). The concentration of total PAHs (TPAHs) in the four seawater samples ranged from 2.297 to 4.001 ng/L and had an average concentration of 3.056 ± 0.727 ng/L. The concentrations of 16 PAHs were determined in each seawater sample, indicating that the analytical method in this study is suitable for the determination of low-concentration PAHs in seawater. Phenanthrene (PHE) is the most dominant compound in seawater samples accounting for 59.6 ± 12.6% of TPAHs, followed by fluorine (FL) accounting for 8.5 ± 3.7%. The contribution of high-ring PAHs to TPAHs is not high (0.5–9.2%), but the observed concentrations can cause a higher risk to aquatic organisms than low-ring PAHs. The diagnostic ratio showed that the sources of PAHs in the seawater collected offshore of southern Taiwan may include mixed sources such as petrogenic, petroleum combustion, and biomass combustion. The results can be used for regular monitoring, which contributes to pollution prevention and management of the marine environment.