Catherine Jackson

Dr. Catherine Jackson


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 July 2024 in High Temperature Corrosion of Materials
Verified
Journal Article
Open access
PDF file
SGSimon Gray
Simon Gray
MMM. Mphahlele
M. Mphahlele
DCD. M. Collins
D. M. Collins
CJCatherine Jackson
Catherine Jackson
MHMark Hardy
Mark Hardy
MTM. P. Taylor
M. P. Taylor
Samples of the Ni-based superalloy, RR1000, were exposed to 98% Na2SO4/2% NaCl salts at 700 °C with a flux of 1.5 µg cm−2 h−1 in flowing air + 300 ppm SO2 for a total of 250 h. Three pre-exposure conditions were studied: a bare reference alloy; fast heating to the test temperature followed by a 100 h hold; heating at a rate of 5 °C min−1 to the test temperature following by a 100 h hold. The surface oxide formed under the latter two conditions were Cr2O3 or NiCr2O4, respectively. The results show corrosion pit formation on the surface of the base, reference sample, and no pits present on the sample with the preformed Cr2O3. Some protection was found for the sample heated at 5 °C min−1 with a delay in the progression to accelerated corrosion attack. Additional testing under moisture containing air was also conducted. This showed no obvious difference in surface oxide morphology under the two tested heating rates for the short-term exposures examined but a difference was noted to be dependent on the moisture content of the air.

14 August 2025 in Materials
Verified
Journal Article
Open access
PDF file
YLYong Li
Yong Li
DMDavies Helen Margaret
Davies Helen Margaret
MHMark Hardy
Mark Hardy
CJCatherine Jackson
Catherine Jackson
MWMark Whittaker
Mark Whittaker
The fatigue performance of a recently developed nickel superalloy disc was investigated at 700 °C in two environments: air and sulphur dioxide (SO2). Prior to testing, specimens were coated with various amounts of sodium sulphate (Na2SO4) and sodium chloride (NaCl) mixed salt (98% Na2SO4 + 2% NaCl), and the influence of both environment and salt loading on corrosion fatigue were assessed. Preliminary results showed that salt exposure in air reduced fatigue strength, with greater damage at higher salt levels. In the SO2 environment, fatigue strength dropped even more due to low-temperature hot corrosion (LTHC). The details of the corrosion morphology formed in both air and SO2 environments are discussed.