This study numerically analyzes the thermal-fluid performance of supercritical hydrogen in regenerative cooling channels with aspect ratios (AR) ranging from 1 to 8 for rocket engine combustion chambers. The study investigates the effects of channel geometry and inlet Reynolds number on heat transmission efficiency, flow behavior, and pressure drop. The SST k-ω turbulence model was validated and utilized in ANSYS FLUENT (2024 R1, (Ansys Inc., Canonsburg, PA, USA) CFD simulations to examine temperature distributions, turbulent kinetic energy, and velocity profiles. The results show that convective heat transfer is improved with higher Reynolds numbers, while pressure drops are increased; the best range for balanced performance is found to be between 35,000 and 45,000. The aspect ratio significantly influences thermal performance; increasing it from 1 to 8 reduces peak wall temperatures by 12–15% but exacerbates thermal stratification and pressure losses. An intermediate aspect ratio (AR = 2–4) was found to optimize both heat transfer enhancement and hydraulic performance. The study provides critical insights for optimizing cooling channel designs in high-performance rocket engines, addressing the trade-offs between thermal efficiency and flow dynamics under extreme operating conditions.
This paper presents a traceability-based framework for managing inconsistencies between desired objectives and estimated performance during conceptual design. A seven-step procedure links measurable objective attributes to functions, selected means, physical elements, and performance evidence. Direction-aware, non-negative violation scores prevent compensating overperformance from masking unmet requirements, while coverage, evaluability, and ambiguity criteria identify deficiencies in the assessment record. A retrospective transmission-device case illustrates two baseline concepts and a reconfigured alternative. Under the declared inputs, their weighted inconsistency indices are 0.1542, 0.1079, and 0.0000, respectively. The baseline indices exclude the unevaluated mandatory attribute A51 and use an evaluated-weight denominator of 0.90. The reconfigured alternative has three E3-class calculations, four E4-class specifications, and one E5-class estimate; these classifications do not establish source completeness or physical verification. Simultaneous adverse bounds for A51 and A71 yield an index of 0.0126, so nominal conformance is not robust over the declared ranges. Missing source records, configuration discrepancies, and the absence of prototype tests limit the findings to a methodological illustration. The contribution is an integrated procedure for documenting deficiencies and corrective actions; comparative effectiveness remains to be established.
Understanding the mechanisms of microstructure evolution and defect formation, and their influence on mechanical properties and fracture mechanisms (from crack initiation to failure stage), is essential for manufacturing high-strength, fatigue-resistant A7075 alloy by selective laser melting (SLM). In this investigation, the A7075 alloy was fabricated using a laser power of 350 W with various hatch spacings of 1.0, 1.5, and 2.0 μm, and scanning speeds of 800, 1100, and 1300 mm/s. The results show that the alloy exhibits an equiaxed grain structure, which varies from coarse grains at small hatch spacing and low scanning speed to fine grains with increasing hatch spacing and scanning speed. The alloys exhibit low tensile strength due to solidification cracking and pores. However, this tensile strength increases with hatch spacing, while it decreases with scanning speed. At small hatch spacing and low scanning speed, fracture occurs through the coalescence of pores and solidification cracking along the weakly bonded grain boundaries (GBs) due to eutectic growth along these boundaries. In contrast, with increasing hatch spacing and scanning speed, fracture occurs through solidification cracking and coalescence of pores. This research provides valuable insights into the microstructure evolution, defect formation, and fracture mechanisms of the A7075 alloy under common processing conditions.