We illustrate the important trade-off between far-field scattering effects, which have the potential to provide increased optical path length over broad bands and parasitic absorption due to the excitation of localized surface plasmon resonances in metal nanoparticle arrays. Via detailed comparison of photocurrent enhancements given by Au, Ag and Al nanostructures on thin-film GaAs devices we reveal that parasitic losses can be mitigated through a careful choice of scattering medium. Absorption at the plasmon resonance in Au and Ag structures occurs in the visible spectrum, impairing device performance. In contrast, exploiting Al nanoparticle arrays results in a blue shift of the resonance, enabling the first demonstration of truly broadband plasmon enhanced photocurrent and a 22% integrated efficiency enhancement.
We study light management in a 430 nm-thick GaAs p-i-n single junction solar cell with 10 pairs of InGaAs/GaAsP multiple quantum wells (MQWs). The epitaxial layer transfer on a gold mirror improves light absorption and increases the external quantum efficiency below GaAs bandgap by a factor of four through the excitation of Fabry-Perot resonances. We show a good agreement with optical simulation and achieve around 10% conversion efficiency. We demonstrate numerically that this promising result can be further improved by anti-reflection layers. This study paves the way to very thin MQWs solar cells.
17 December 2012 in Journal of Physics D: Applied Physics
Insertion of quantum wells (QWs) extends the absorption edge to a longer wavelength than the value of a p-i-n cell without the QWs, which is preferable for the improved current matching of a InGaP/GaAs/Ge multijunction cell. The QWs, however, reduce the open-circuit voltage (Voc) and degrade the fill factor; the latter is significant for a large number of QWs that are mandatory for sufficient light absorption. As a structure to minimize these drawbacks, a QW superlattice, a strain-balanced In0.13Ga0.86As (4.7 nm)/GaAs0.57P0.43 (3.1 nm) stack, was implemented by metalorganic vapour-phase epitaxy. It brought about an enhancement in short-circuit current density (3.0 mA cm−2) with a minimal drop in Voc(0.03 V) compared with a p-i-n cell without the superlattice. The collection efficiency of photocarriers from the wells to an external circuit was evaluated: the efficiency was above 0.95 for the superlattice, while it was below 0.8 at a large forward bias for a conventional QW cell with thicker barriers. With the fast electron–hole separation in the superlattice owing to tunnelling transport, the superlattice cell exhibited a steeper increase in Voc as a function of the sunlight concentration ratio than the conventional QW cell: at the concentration ratio of 50, the value of Voc for the superlattice cell was almost equivalent to the value of the GaAs p-i-n cell without QWs. As a possible mechanism behind such an enhancement in Voc, photocurrent generation by two-step photon absorption was observed, using the electron ground state of the superlattice as an intermediate state.
The direct conversion of solar energy to electricity can be broadly separated into two main categories: photovoltaics and thermal photovoltaics, where the former utilizes gradients in electrical potential and the latter thermal gradients. Conventional thermal photovoltaics has a high theoretical efficiency limit (84%) but in practice cannot be easily miniaturized and is limited by the engineering challenges of sustaining large (>1,000 K) temperature gradients. Here we show a hot-carrier-based thermophotonic solar cell, which combines the compact nature of photovoltaic devices with the potential to reach the high-efficiency regime of thermal photovoltaics. In the device, a thermal gradient of 500 K is established by hot electrons, under Stokes illumination, rather than by raising the temperature of the material itself. Under anti-Stokes (sub-bandgap) illumination we observe a thermal gradient of ∼20 K, which is maintained by steady-state Auger heating of carriers and corresponds to a internal thermal up-conversion efficiency of 30% between the collector and solar cell.
Hot-carrier solar cells offer the opportunity to harvest more energy than the limit set by the Shockley–Queisser model by reducing the losses due to the thermalization of photo-generated carriers. Previous reports have shown lower thermalization rates in thinner absorbers, but the origin of this phenomenon is not precisely understood. In this work, we investigate a series of ultrathin GaAs absorber layers sandwiched between AlGaAs barriers and transferred on host substrates with a gold back mirror. We perform power-dependent photoluminescence characterizations at different laser wavelengths from which we determine the carrier temperature in four absorber thicknesses between 20 and 200 nm. We observe a linear relationship between the absorbed power and the carrier temperature increase. By relating the absorbed and thermalized power, we extract a thermalization coefficient for all samples. It shows an affine dependence with the thickness, leading to the identification of distinct volume and surface contributions to thermalization. We confirm that volume thermalization is linked to LO phonon decay. We discuss the origin of the interface-related thermalization, showing that the effect of LO phonon transport is negligible. Overall, this work sheds new light on thermalization processes in ultrathin semiconductor layers and introduces a method to compare the performance of hot-carrier absorbers.
Quantum dots photonic devices based on the III–V compound semiconductor technology offer low power consumption, temperature stability and high-speed modulation. We fabricated GaAs nanodisks (NDs) of sub-20-nm diameters by a top-down process using a biotemplate and neutral beam etching (NBE). The GaAs NDs were embedded in an AlGaAs barrier regrown by metalorganic vapor phase epitaxy (MOVPE). The temperature dependence of photoluminescence emission energies and the transient behavior were strongly affected by the quantum confinement effects of the embedded NDs. Therefore, the quantum levels of the NDs may be tuned by controlling their dimensions. We combined NBE and MOVPE in a high-throughput process compatible with industrial production systems to produce GaAs NDs with tunable optical characteristics. ND light emitting diode exhibited a narrow spectral width of 38 nm of high-intensity emission as a result of small deviation of ND sizes and superior crystallographic quality of the etched GaAs/AlGaAs layer.