In this work, a modulated photothermal radiometry principle is applied in a scanning configuration. This technique was developed with the aim of performing imaging and thermal characterization at the microscale and exploring characteristic times lower than those accessible by infrared thermography. The use of a heat source smaller than the measurement area provides high sensitivity to in-plane heat diffusion. Application to quantitative thermal characterization of advanced micro-structured materials is demonstrated.
A transient 3D thermal model based on the thermal quadrupole method, coupled to ray tracing analysis, is presented. This methodology can predict transient temperature maps under any time-fluctuating irradiance flux—either synthetic or experimental—providing a useful tool for the design and parametric optimization of concentration photovoltaics systems. Analytic simulations of a concentration photovoltaics system thermal response and assessment of in-plane thermal gradients induced by fast tracking point perturbations, like those induced by wind, are provided and discussed for the first time. Computation times for time-resolved temperature maps can be as short as 9 s for a full month of system operation, with stimuli inspired by real data. Such information could pave the way for more accurate studies of cell reliability under any set of worldwide irradiance conditions.
1 October 2024 in Review of Scientific Instruments
In this work, scanning photothermal radiometry is used for imaging and to characterize a submicron crack. From the thermal images, the evolution of the crack is mapped in the space with micrometer resolution. A vertical contact interface at the steel–steel junction is used to represent a micro-crack with a thickness less than 0.5 μm. The thermal quadrupole approach is used to model the heat transfer within the semi-infinite vertical crack. Then, using the phase mapping and that calculated from the model, the estimation of both the equivalent thermal boundary resistance of the interface and the average interface thickness was done.
In the context of the non-destructive testing of pieces produced through additive manufacturing, this research focuses on investigating porosity using images obtained via scanning photothermal radiometry from Ti–6Al–4V samples. Variations in the material’s porosity as a function of the electron beam melting process parameters are revealed through photothermal images. The measured thermal signature is influenced by changes in the material’s apparent thermal diffusivity, which is affected by the presence of pores within the bulk material.