Earth retaining structures are constructed to withstand lateral pressure from backfill soil and surcharge pressures from the foundations of adjacent structures. Although sands are considered as the most suitable backfill material for retaining walls due to their high permeability, currently the scarcity of this natural material has raised serious environmental concerns. This study will propose the usage of building derived materials (BDM) as a partial replacement for sand as backfill material for the retaining walls. The utilization of this waste material will help to reduce the cost related to the disposal of waste materials, as well as reducing the carbon footprint, therefore making the process eco-friendly and sustainable. Experimental studies will be conducted on a laboratory scale prototype rigid, nonyielding retaining wall, which can rotate about its base to simulate rotational failure conditions. The width of the backfill was 0.35, 0.5, and 0.65H to assess its effect on the variation of earth pressures (H = height of the retaining wall). The experimental results indicate that the earth pressures were not significantly enhanced by the addition of BDM to sand, which suggests that BDM could be used as an effective lightweight backfill. The optimum pressure was obtained by mixing 20% of BDM with red soil. For backfills that had sufficient widths, the failure surfaces had adequate space to fully develop, whereas it had a limited extension in a narrow backfill. An increase in backfill width (b) decreased the rotation of the wall, therefore reducing the probability of rotational failure. Numerical simulations using finite element software PLAXIS 2D are conducted with the experiments to validate the observations. The numerical results suggest good agreement with that of experimental results.
26 June 2025 in International Journal of Geosynthetics and Ground Engineering
The technique of increasing load bearing capacities of sand using addition of waste materials is economically viable and eco-friendly. In 2013, India reportedly produced 530 million tones of construction and demolition waste (CDW), as a result of construction of new infrastructure and renovation of existing structures. The primary component of CDW is building derived materials (BDM). The present study primarily aims to utilize these waste materials in improving the load bearing capacities of cohesionless soil having low relative density. Laboratory investigations are carried out to determine the strength and load carrying capacity of sand partially replaced with different percentages of BDM. Test results indicate that addition of 17–23% of BDM effectively increases shear strength and load carrying capacity of sand. A finite element model is developed in commercially available software to simulate the behavior of sand-BDM mix as a foundation material and it shows a good agreement with the experimental results. Experimental and the numerical studies indicate that naturally available loose sand can be partially replaced with BDM to improve its properties as a foundation bed, while simultaneously reducing the need for disposal of BDM as solid waste.