Incorporating pigments into polymers can be done for various purposes, including the introduction of color, interfacial effects, or aesthetics. If these pigments are to disperse properly, then the process of extrusion must be optimized. During polymer compounding extrusion, three effective processing factors were investigated: feed rate (FR), speed (Sp.) and temperature (temp.) for a colored compounded polycarbonate (PC) grade (30/70%). The processing design techniques were obtained by applying design experiments in a response surface methodology (RSM) to blend two polycarbonates with pigments and optimize the processing temperatures at center points. The first study decided to utilize the response surface approach of Box–Behnken design (BBD) to design an experiment to optimize the process parameters. Statistical significance was demonstrated by the model passing all diagnostic tests. Furthermore, the three processing factors strongly impacted the characteristics of the tri-stimulus color, according to the results from a variance analysis. The second study identified process variables for the same PC grade at the center level, 25 kg/h FR, 750 rpm speed, and (255 °C) temp. The characterization and scanning morphology were examined using MicroCtscanner image analysis, SEM, DOM, rheology, FT-IR, and color-pigmented values were measured using a color spectrometer. The output response was significantly impacted when excellent color dispersion was observed with few agglomerates and less differences in colors at the center point. By characterizing these results and having good insight into color difference output and processing condition relationships, which have an adverse effect on color variation characteristics and minimize recycling compounds of different grades, results in cleaner environments benefits.
This research article concentrates on process conditions in addition to improving color selections in polymer compounders and developing more accurate simulation models. The feed rate (FR), temperature (T) and screw speed (SS) are three processing variables that the research investigates using general trends (GTs) and Box–Behnken design (BBD) response surface methodology. The identical set of processing settings was tweaked at three separate phases independently of one another. This study uses the experimental design to investigate process parameters’ optimization while holding all other parameters constant. This design was given the name GT. To develop this design and its statistical optimization, this study used the software of the design expert method. A regression model was run in this design, which displayed collective as well as individual effects of the parameters on color images. The values of tri-stimulus color with the best optimization had the smallest proper color variance (dE*). To obtain information on pigment characteristics, an SEM image analysis was conducted, which aids in improving future designs and overcoming manufacturing issues that affect color fluctuation properties and waste reduction for various chemical grades, both of which enhance environmentally friendly processes.
Wood is a natural sustainable orthogonal material. It is a renewable construction material but measuring its strength properties is costly, time-consuming, may provide significant variations. Standard methods for measuring wood strength and moisture characteristics are destructive in nature. Therefore, the necessity to establish innovative nondestructive methods for wood application is critical. This paper presents the development and use of Free Space Microwave Transmission Line Nondestructive Testing (FSMTL-NDT) to evaluate moisture and strength properties of wood. The measured complex permittivity of wood using the proposed FSMTL-NDT was related to the moisture and strength properties of wood. Seventeenth Malaysian wood spices were collected and tested to determine its physical, mechanical and dielectric properties. Wood samples also tested at various moisture content and at different rain angles. The results indicate that wood moisture content and compressive strength could be predicted using the permittivity of wood. The results also show that, in the longitudinal direction, the dielectric constant and loss factor are observed to be higher compared to those in the radial and tangential directions. However, there isn't a substantial distinction between the dielectric properties in the radial and tangential directions. It's noted that dielectric constants decrease as the angle between the electric field direction and the timber grain direction increases. Leveraging the measured dielectric constants via microwave methods enables the determination of the angle between the electric field and timber grain direction.