Birnessite-type MnO2 (BM) is a promising anode material for lithium-ion batteries (LIBs) due to its high theoretical capacity and low lithiation voltage. However, its poor conductivity and structural instability limit long-term performance. In this work, we report an optimized in situ hydrothermal synthesis of BM–graphene (BM–Gr) composites, guided by thermodynamic equilibrium modeling using the HSC Chemistry software package to model phase formation. The effects of NaOH/H2O2 concentration, reaction time, and graphene loading on phase stability and morphology were systematically studied and validated experimentally. Structural, morphological, and compositional analyses (XRD, FE-SEM, EDS, TEM, and XPS) confirmed that pure birnessite was successfully synthesized and uniformly anchored on graphene, without secondary phases such as Mn3O4 or MnOOH. Graphene incorporation induced oxygen vacancies (VO) and Mn–O–C interfacial bonding, narrowing the bandgap from 1.7 (BM) to 1.4 eV (BM–Gr). The optimized BM–Gr electrode delivered an initial lithiation capacity of 2097 mAh g−1 and maintained 758 mAh g−1 after 175 cycles at 450 mA g−1, compared to 86 mAh g−1 for BM after 50 cycles. Electrochemical impedance spectroscopy revealed an ~ 18-fold increase in the Li⁺ diffusion coefficient after cycling (7.10 × 10–13 to 1.27 × 10–11 cm2 s−1), attributed to improved ion transport pathways and enhanced structural stability from the conductive graphene framework. These results demonstrate that thermodynamically guided BM–Gr synthesis provides a viable strategy for producing structurally robust, high-capacity anodes for next-generation LIBs.
Aluminum-ion batteries (AIBs) are emerging as promising alternatives to lithium-ion batteries due to their cost-effectiveness and resource abundance. However, their practical application is hindered by low capacity, poor cycle life, and limited rate capability. In this study, δ-MnO2 and δ-MnO2/Graphene composite cathodes are developed and tested in aqueous aluminum-ion batteries (AAIBs) using a mixture of 0.5 M Al2(SO4)3 and 0.4 M MnSO4 as the electrolyte. The electrochemical properties are evaluated alongside treated aluminum (TAl) and Zn–Al alloy anodes. Among the configurations tested, the δ-MnO2/Graphene|0.5 M Al2(SO4)3, 0.4 M MnSO4|Zn–Al system showed the best performance, achieving a high discharge voltage of 1.63 V, a specific capacity of 746 mAh g−1, and excellent cycling stability over 352 cycles. The stabilizing effect of graphene, due to increased oxygen vacancies and the formation of Mn–O–C bonds, enhances electron and ion transport, thereby improving cathode integrity and the overall performance of the AAIB. Additionally, the Zn–Al alloy anode extends the battery’s cycle life compared to the TAl anode. This work demonstrates the potential for low-cost, high-performance AAIBs, paving the way for more sustainable and scalable energy storage solutions.