Ayşenur güngör borsöken

Dr. Ayşenur güngör borsöken


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 March 2026 in Odontology
Verified
Journal Article
Open access
GKGökçe Keçeci
Gökçe Keçeci
ZGZehra Güner
Zehra Güner
SGsimge gümüş
simge gümüş
ABAyşenur güngör borsöken
Ayşenur güngör borsöken
The aim of this study was to evaluate the color stability of contemporary bioactive restorative materials, including Equia Forte HT, GC Fuji II LC, ACTIVA BioACTIVE, Cention N, and a conventional composite resin, and to comparatively analyze their color changes following thermal aging and exposure to iron preparations. A total of 120 specimens were fabricated from five different restorative materials: Equia Forte, Cention N, ACTIVA BioACTIVE, Fuji II, and SolareX ( n = 24 per group). All samples were initially subjected to thermal cycling, followed by immersion in two iron-containing solutions (Ferrum and Ocean) and one control solution (distilled water) for 72 h. Measurements were recorded at baseline (after 24 h of immersion in distilled water), after thermal cycling, and following staining procedures. Color difference (ΔE00) and lightness ( L *) values were quantitatively assessed using a dental spectrophotometer based on the CIEDE2000 color evaluation system. Statistical analyses were performed using the Shapiro–Wilk test, Kruskal–Wallis test, and generalized linear models (GLM) approach. All analyses were conducted with SPSS version 22.0, with a significance level set at p < 0.05. A statistically significant difference was observed between the baseline and post-aging color values ( p < 0.05). Among the materials tested, Equia Forte exhibited the greatest degree of color change, while ACTIVA BioACTIVE and SolareX demonstrated similar and comparatively lower levels of discoloration. Although no statistically significant difference was found between ACTIVA BioACTIVE and SolareX regarding total color change from baseline to final measurements ( p > 0.05), the ΔE2 values of Equia Forte, Cention N, and Fuji II were significantly higher than those of the SolareX group ( p < 0.05). Furthermore, significant differences were noted in the L * values before and after aging depending on the restorative material used ( p < 0.05). Equia Forte showed the lowest L * values at both baseline (L1) and post-aging (L2), whereas ACTIVA BioACTIVE and SolareX presented the highest values. The findings of this in vitro study suggest that the color stability of restorative materials is influenced by intrinsic material properties as well as exposure to thermal aging and staining solutions. These factors should be considered when selecting restorative materials, particularly in esthetically demanding clinical situations.

3 January 2026 in Coatings
Verified
Journal Article
Open access
PDF file
ZGZehra Güner
Zehra Güner
GKGökçe Keçeci
Gökçe Keçeci
SOSadık Olguner
Sadık Olguner
HÇHAKAN ÇANDAR
HAKAN ÇANDAR
ABAyşenur güngör borsöken
Ayşenur güngör borsöken
STSebnem Turkun
Sebnem Turkun
This study aimed to evaluate the effects of thermal cycling and restorative material type on surface roughness of material surfaces and dental interfaces using a non-contact profilometer. Ninety Class V cavities (2 mm × 4 mm × 2 mm in height, width, and depth) were prepared on extracted third molars and restored with four bio-interactive materials (Equia Forte, Cention-N, Activa BioActive Restorative, Fuji II LC) and one composite resin (Solare-X) (n = 18/group). After polishing (Optidisc), initial surface roughness (Sa, µm) was measured following 24 h immersion in distilled water. Measurements were performed at cement/material (400 × 1600 μm2), enamel/material (1600 × 400 μm2), and material surfaces (800 × 800 μm2). Samples underwent 10,000 thermal cycles (5–55 °C) to simulate aging, and roughness was re-measured. Data were analyzed with two-way repeated measures ANOVA and Tukey’s post hoc test (p < 0.05). Solare-X showed the lowest roughness, while Fuji II LC and Activa BioActive Restorative were smoother than Cention-N and Equia Forte (p < 0.01). All materials exhibited significant roughness increases after thermal cycling (p < 0.01). Cement/material and enamel/material interfaces consistently showed higher roughness than material surfaces (p < 0.01). Thermal cycling significantly increased surface roughness of all tested materials. Interfaces demonstrated greater roughness than material surfaces, indicating higher susceptibility to plaque retention and potential risk for long-term restoration success.

26 August 2024 in HRU International Journal of Dentistry and Oral Research
Verified
Journal Article
Open access
PDF file
ABAyşenur güngör borsöken
Ayşenur güngör borsöken
DSDerya Gürsel Sürmelioğlu
Derya Gürsel Sürmelioğlu
SÖSongül Özdögen
Songül Özdögen
Aim: This study aimed to evaluate the effect of anxiety level, dental fear, anxiety on oral health quality of life oral, and dental health in Hashimoto's thyroiditis patients. Materials and Methods: Ninety adult individuals were included from Gaziantep University Faculty of Dentistry. All participants were asked about demographic parameters (age, gender), socio-economic status (education, marital status), and oral hygiene habits. The OHIP-14 and OHRQoL-UK questionnaires were used to asses the effect of individuals' oral health on their quality of life. Dental anxiety levels were evaluation with the Modified Dental Anxiety Scale (MDAS). Statistical analysis was performed using IBM SPSS Statistics 22.0. Result: There were no significant differences for Sociodemographic data, dental habits, age, marital status, educational status, smoking, frequency of brushing tooth, frequency of visiting the dental clinic in OHIP-14, OHRQoL, and MDAS survey scores (p > 0.005). However, there was a statistically moderate positive correlation between the total OHIP-14 scores and the MDAS scores (r = 0.309; p < 0.003). Additionally, a moderate negative correlation was showed between the total OHRQoL and the MDAS scale (r = 0.307; p < 0.003). Conclusion: In conclusion, this study showed that patients' quality of life regarding oral and dental health was low, regardless of individual factors. It was found that dental anxiety was lower in patients with HT, and a significant correlation betwen the quality of life and anxiety level was observed.