The influence of the running-in process operating parameters on tribological properties of the block-on-disc samples in lubricated sliding conditions is analyzed and discussed in detail. Different running-in regimes are achieved by varying the normal load and sliding speed. After the running-in period, during which the operating parameters are varied, all samples are placed in a working regime under the same set of operating conditions. At the end of the running-in period, as well as at the end of the working period, an analysis of the changes in the surface roughness, microhardness, wear rate, and coefficient of friction is performed. Less desirable properties in terms of wear rate and steady-state coefficient of friction are noticed for the samples that were run-in with the operating conditions which were the same as the working regime operating conditions. In the defined test conditions, it is shown that the intensity of normal load applied during the running-in process has a dominant influence on the amount of wear and coefficient of friction value. It was also shown that the running-in process can significantly improve the roughness of the initially rough contact surfaces. The results of experimental testing indicate that the variation of the operating parameters during the running-in process can be used to improve the working ability of the sliding contact surfaces under the mixed lubrication regime.
Nowadays, rapid prototyping technologies are available at very affordable prices. This is the main reason why they are being used in almost all industry sectors. 3D printers are currently being widely used for rapid prototyping and development of the new products. However, taking into account the permanent progress of rapid prototyping materials mechanical characteristics (usually different kinds of plastics), 3D printers are sometimes used even for production of the failed parts replacements – operating at the low load and rotational speed conditions. This is the main goal of this paper – to establish optimal 3D printing parameters (printing direction, layer height and percent of infill) which will allow printed gears to replace failed steel gears, for at least some time, enough for spare steel gears to be produced and delivered on site. Taking into account previously mentioned facts, the application of the 3D printed gears can potentially provide the reduction of maintenance delays in different industrial facilities (factories, workshops, etc.) which will consequently lead to significant energy and financial savings.
Non-movable threaded joints (bolted connections) and movable threaded joints (power screws) are subassemblies that have a large field of application in the mechanical industry. With these subassemblies, a part of the input energy in the form of torque is spent on overcoming friction on the contact sliding surfaces. These energy losses mostly depend on the geometric and tribological characteristics of the threaded joint. Compared to bolted joints, power screws consume significantly more energy to perform their elementary function. Bolted joints have a much larger field of application in the mechanical industry. In the case of bolted joints metric thread is the most common, and in power screws, threaded joints with a trapezoidal thread. Accordingly, this paper analyses the effects of the coefficient of friction and geometric and kinematic parameters on the energy efficiency of trapezoidal and metric threaded joints. The performed analysis can be used to select the optimal parameters of the threaded joints from the aspect of energy efficiency during the design of new or reconstruction of existing machine structures.