The evolution of the sedimentary environment in the Early Carboniferous Dawuba Formation of the Qiannan Depression significantly controlled the distribution of low-total organic carbon (TOC) sediments. In this study, the core samples were analyzed by thin section microscopy, field emission-scanning electron microscopy, pyrite morphology, X-ray diffraction, and geochemical analysis (TOC, sulfur, organic petrography, and major and trace elements). The formation is vertically divided into two members from bottom to top: Member 1 (average TOC = 1.15%) and Member 2 (average TOC = 0.88%). Depositional environment parameters indicate that Member 1 was in a suboxic-oxic transition environment, with weak detrital influx, and moderate paleoproductivity (more developed algae). Member 2 evolved into a stable oxic environment, with significantly enhanced detrital influx and reduced paleoproductivity. The correlations between multiple geochemical proxies (paleoredox, paleoproductivity, and terrestrial detrital influx) and TOC content indicate that high productivity in Member 1 was the main driver of organic matter accumulation, but the suboxic-oxic environment limited preservation efficiency (1.00% < TOC < 2.00%). Member 2, deposited during sea-level fall, experienced long-term oxic conditions and low productivity due to shallower water. Nevertheless, the partial reduction in the exposure time of organic matter within the oxic water column-driven by rapid detrital accumulation-represents a critical mechanism favoring organic-poor sediments (TOC < 1.00%). In conclusion, the development of low-TOC sediments in the Dawuba Formation reflects a transition from a relatively deep to shallow water column, where the synergistic effects of redox conditions, paleoproductivity, and terrigenous detrital influx controlled the distribution and enrichment of organic matter.
In this study, shale samples with diverse lithofacies from the Lower Silurian Longmaxi Formation in the Fuling Field were investigated to evaluate the variations in pore characteristics and methane adsorption capacity (MAC) of different shale lithofacies. A set of experiments were performed, such as total organic carbon (TOC) content, X-ray diffraction (XRD), field emission–scanning electron microscopy (FE-SEM), low-pressure gas (CO2/N2) adsorption, and high-pressure methane adsorption. Combined with TOC content and mineral composition, three types of shale lithofacies were identified, including organic-rich (OR) argillaceous-rich siliceous (S-3) shale lithofacies, organic-moderate (OM) argillaceous/siliceous mixed (M-2) shale lithofacies, and organic-lean (OL) siliceous-rich argillaceous (CM-1) shale lithofacies. Through detailed comparative analyses, we found that OR S-3 shales possess the maximum TOC content, the most developed heterogeneous organic micro-mesopores, the largest pore volume (PV), and the highest pore surface area (PSA); consequently, they display the strongest MAC. Conversely, OL CM-1 shales have the lowest TOC content and the highest clay content, and thus the smallest PSA and the poorest methane adsorption performance. In conclusion, considering the excellent gas storage potential, sustained shale gas production, and brittle response to hydraulic fracturing, OR S-3 shales are superior to shale gas exploration and exploitation compared with OM M-2 and OL CM-1 shales.
Tectonic deformation can substantially change the pore characteristics and the resulting methane adsorption capacity of shales; thus, it strongly influences shale gas exploration and development in structurally complex areas of southern China. Two sets of shales with identical lithofacies that were derived from either structurally stable or deformed regions were collected at Fuling Field to evaluate the response of their pore properties and methane adsorption behavior to tectonic deformation through field emission scanning electron microscopy (FE-SEM), low-pressure gas (CO2/N2) adsorption, and high-pressure methane adsorption experiments. Three primary shale lithofacies were identified in each set of shales: organic-lean (OL) siliceous-rich argillaceous (CM-1) shale lithofacies, organic-moderate (OM) argillaceous/siliceous mixed (M-2) shale lithofacies, and organic-rich (OR) argillaceous-rich siliceous (S-3) shale lithofacies. In the stable region, organic matter (OM) pores dominated the pore types of OR S-3 shales, whereas the primary pore types of OL CM-1 shales were clay cleavage micro-fractures. OM M-2 shales exhibited a composite type of OM pores and clay cleavage micro-fractures. Compared with structurally stable shales, the original OM-hosted and clay-related pores in structurally deformed shales were extensively compacted or even closed due to tectonic compression during structural deformation. Despite pore collapse, two new types of tectonic micro-fractures were generated and found to be well developed in deformed shales through the rupture of brittle minerals in OR S-3 shales and the deformation of clay minerals in OL CM-1 shales. Simultaneously, organic matter–clay aggregates that formed during tectonic compression constituted a distinctive structure in deformed OM M-2 shales. As a result, the deformed shales displayed a decrease in their micropore and mesopore volumes, as well as a decrease in their pore surface areas, because of strong tectonic compression accompanied by an increase in the macropore volume due to the development of tectonic micro-fractures. Furthermore, the large pore surface areas in structurally stable shales could supply abundant adsorption sites and facilitate the enrichment of adsorbed gas. The expanded macropore volumes in structurally deformed shales could provide more storage spaces that are favorable for the accumulation of free gas.
As a key preliminary strategic area for continental shale hydrocarbon exploration, the Southwestern Tarim Depression contains thick, high-TOC lacustrine shale on the Jurassic Yangye Formation, yet its strata still lack clear definition in precise lithofacies architecture and sedimentary evolution due to low exploration intensity. Based on core observation, thin section identification, XRD, XRF, TOC and elemental analyses, nine shale lithofacies are classified into four main types. Geochemical data reveal distinct depositional settings for each lithofacies. The laminated-bedded organic-rich argillaceous shale formed during the maximum lake transgression in a warm-humid freshwater deep lake with strong reduction. The bedded-massive organic-rich felsic shale developed in a relatively shallow freshwater lake affected by episodic terrigenous input. The bedded-massive medium-organic felsic shale occurred in a stable sub-humid freshwater semi-deep lake with obvious sediment dilution. The laminated-bedded organic-rich dolomitic-calcitic mixed shale mainly accumulated in an arid, evaporative closed lake with high salinity and strong water stratification. Vertically, the study area experienced three evolutionary stages: argillaceous shale, felsic shale and dolomitic-calcitic mixed shale. Lithofacies with TOC > 1.5% possess abundant organic matter and provide fundamental hydrocarbon-generating materials. This study provides references for reservoir evaluation and prospect selection in the study area.