Geometrical information of the 3D weld pool surface provides clues to determine the penetration state whose monitoring and feedback control are crucial for critical applications involving high temperatures and pressures. In this paper, a biprism stereo vision system is established to sense the weld pool surface under different penetration states during pulsed gas metal arc welding (GMAW-P) with V groove joint. Only one optical filter is used to block out the arc and capture a clear image of the weld pool during the base current period in GMAW-P. While most of the weld pool surface is textureless, there are a few features such as slags that are detectable. Hence, during the stereo matching sparse feature corners are detected and credibly matched in pairs, followed by a disparity region growing step to produce a semi-dense and unambiguous disparity map. Polynomial interpolation is applied to obtain sub-pixel disparity for every matched pixel. Finally, the point cloud and triangle mesh representation of the weld pool surfaces with different penetration states, partial, full, and over penetration, are presented. The experimental results verified the effectiveness of the proposed biprism stereo vision method in monitoring the weld penetration state.
31 March 2022 in Materials Science and Engineering: A
In this study, 2198 Al-Li alloy, a low density and high-performance material for aerospace equipment, was welded using ultrahigh-frequency pulse alternating current with cold metal transfer (UHF-ACCMT). Influence of different ultrahigh-frequency on the formation, porosity, microstructure, microhardness and tensile strength of the welded joints were investigated. The results showed that the coupled ultrahigh-frequency current generated electromagnetic force to stir the liquid metal of molten pool. The weld formation became much better with metallic luster and uniform ripples at frequency of 60 kHz and 70 kHz. The porosity was the minimum at frequency of 60 kHz. Furthermore, the molten pool was scoured and stirred by the electromagnetic force which provided the thermal and dynamic conditions for nucleation and grain refinement, the width of fine equiaxed grain zone became larger, and the number of equiaxed non-dendrite grains increased. With the grain refining and crystallize transition, the average microhardness and tensile strength of the joints at frequency of 60 kHz reached up the highest value, 116 HV0.1 and 338 MPa, respectively. The fracture of the welded joints presented the characteristics of quasi-cleavage fracture.