In this work, we reported on the development of lithography-free technology for the fabrication of nanopatterned Si substrates. The combination of two phenomena, the solid-state dewetting process and metal-assisted wet chemical etching, allowed for fabrication of Si nanocolumns on large areas in a relatively simple way. The process of dewetting the thin metal layer enabled formation of nickel nanoislands, which were used as a shadow mask in the deposition of a catalytic metal pattern. Application of the two-stage dewetting process with the repetition of the metal deposition and annealing step enabled us to obtain a significant increase in the surface coverage ratio and the surface density of the nanoislands. As a catalytic metal, a gold layer was applied in the metal-assisted wet chemical etching process. The obtained columnar nanostructures showed a great verticality and had a high aspect ratio. In the conducted studies, the maximum etching rate (at RT) was higher than 1.2 μm min−1. The etching rate increased with increasing concentration of oxidizing (H2O2) and etching (HF) agent, with a tendency to saturate for more concentrated solutions. The etching rate was significantly higher for Si substrates with a crystallographic orientation (115) than for (111), but there was no privileged direction of etching except for the direction vertical to the substrate. With increasing layer thickness of the catalytic metal a decrease in the metal-assisted wet chemical etching process efficiency was observed. The developed technology allows for fabrication of patterned substrates with a wide range of lateral dimension of nanocolumns and their density.
2 June 2017 in Journal of Materials Science: Materials in Electronics
This paper presents an analysis of thermal oxidation kinetics for Aluminium nitride (AlN) epitaxy layers using three methods: dry, wet and mixed. The structures thus obtained were examined by means of scanning electron microscope, energy-dispersive X-ray spectroscopy, spectroscopic ellipsometry and secondary ions mass spectroscopy. On the basis of the investigation results, a model of layer structure after oxidation was proposed, the thickness of the layers was assessed and the refractive indices for particular layers were determined. The modelling results prove that AlN thermal oxidation in dry oxygen follows the logarithmic law, wet oxidation follows the parabolic law, whereas mixed oxidation follows the linear law.