The final oxide scale was triple-layered, consisting of a WO 3 -rich outmost layer, Al 2 O 3 -concentrated middle layer and TiO 2 -concentrated inner layer.
Effects of C addition on the microstructures of as-cast Cu–Fe–P (mass fraction) alloys were systematically investigated. The results show that C addition can refine the matrix microstructure and make Fe particles finer. The Fe particles observed in both the non-C-alloyed and C-alloyed specimens are α-Fe particles, which possess a body-centered cubic (bcc) structure with a Nishiyama–Wassermann orientation relationship with the matrix. C is reported to be an γ-Fe stabilizer in the literature. The reason for the difference between the phases of Fe particles observed in this study, and that reported in the literature, are finally discussed. Additionally, C addition facilitates the decomposition of the supersaturated solid solution which occurs by the simultaneous precipitation of very fine Fe particles. Such initial decomposition product has an face-centered cubic (fcc) structure with a cube-on-cube orientation relationship with the matrix.
The coating is one of the biggest problems in the recycling of coated multicomponent hardmetal scraps. The isothermal oxidation behavior of WC-Co multicomponent cemented carbide inserts with a TiCN/Al2O3/TiN hard coating in the recycling process was investigated. The oxidation rate slowed down as the protective coating blocked element diffusion. A rapid oxidation rate was obtained when they were milled into powders and isothermally oxidized at 900 °C. A rapid path for element diffusion was provided by the defects, which were promoted by stress, expansion, and gas volatilization. Both the TiN and TiCN layers were oxidized to a porous TiO2 scale, while the Al2O3 phase remained and the dense Al2O3 layer acted as a barrier for its good oxidation resistance. Pieces of the Al2O3 layer were obviously seen in the final oxides. This provides critical information to reduce the negative effect of coatings and improve the performance of recycled WC powders and hard alloys.