False data injection attack (FDIA) can pose a severe threat to the distribution networks (DN), and the accurate detection of FDIA plays a key role in the safe and reliable operation of the DN. In this article, an end-edge-cloud collaboration-based detection framework is proposed to detect FDIA in the DN. First, in order to effectively preserve the privacy of different stakeholders in the DN and solve the problem of data island, a federated-learning-based edge-cloud collaboration mechanism is designed according to the proposed end-edge-cloud collaboration framework to jointly train the local FDIA detection models and eventually build a comprehensive FDIA detection model. Then, considering the temporal–spatial correlation of measurement data, a local data-driven FDIA detection model is proposed based on a novel temporal–spatial graph convolutional network, which can extract temporal–spatial features of the measurement data and improve the FDIA detection performance. In general, compared with the traditional centralized FDIA detection methods, the proposed method can make full use of the computational capacity of distributed edge devices and reduce the pressure of computation on the control center. Finally, simulation results based on the modified IEEE 14-bus and IEEE 118-bus distribution systems indicate that the proposed method can effectively improve the accuracy of FDIA detection compared with other methods.
Lithium-ion batteries are widely used in power grids as a common form of energy storage in power stations. The state of charge (SOC) and state of health (SOH) reflect the capacity and lifetime variation in the Li-ion batteries, and they are important state parameters of Li-ion batteries. Therefore, the establishment of accurate SOC and SOH prediction models is an essential prerequisite for the correct assessment of the status of lithium batteries, the improvement of the operational accuracy of energy-storage stations, and the development of maintenance plans for energy-storage stations. This paper first analyzes the correlation between SOC and SOH, and then proposes a joint SOC and SOH prediction model using the particle swarm optimization (PSO) algorithm to optimize the extreme gradient boosting algorithm (XGBoost), which takes into account the dynamic correlation between SOC and SOH dynamics, thus enabling more accurate SOC and SOH prediction. Finally, the prediction model is validated using the Oxford battery aging dataset. The correlation between SOC and SOH is verified by comparing the joint prediction results with the SOC individual prediction results. Then, the prediction results of the PSO-XGBoost model, the traditional XGBoost model, and the long short-term memory neural network are compared to verify the effectiveness and accuracy of the PSO-XGBoost model.
This paper proposes an end-edge-cloud collaboration based electric vehicles (EVs) aggregator control method that aligns with the EVs-charging stations (CSs)-aggregator architecture of EV aggregator for multiple frequency regulation (MFR), including primary (PFR) and secondary frequency regulation (SFR). This method uses frequency regulation capacity (FRC) as the criterion for calculating MFR tasks, and through the proposed FRC assessment method, the user charging demand is satisfied and battery degradation is reduced during MFR. For PFR, a dynamic droop control based on FRC is proposed at the edges, while for SFR, proportional power sharing is proposed in the edge-cloud collaboration. These methods facilitate efficient utilization of FRC in calculating the MFR task for each CS. However, the disparity in time scales between PFR and SFR introduces a power overrun issue, compromising the accuracy of MFR. To overcome this challenge, a consensus-based edge-edge collaboration mechanism is developed to redistribute the overrun tasks in a distributed way. Furthermore, a two-stage model predictive control is proposed in end-edge collaboration, accounting for the FRC and response characteristic differences between fast and slow charging EVs, to allocate the MFR task from CSs to EVs. Finally, the validity of this method is verified by simulation.
8 September 2023 in IEEE Transactions on Sustainable Energy
Harnessing the rapid active power regulation potential of aggregated distributed photovoltaics (PVs) to support the bulk power system is crucial under high-penetration PV scenarios. In this article, based on a hierarchical architecture, the optimization and control strategies of distributed PVs are proposed to realize rapid active power support. In the upper level, to achieve reliable and rapid active power allocation, an optimal active power flow model incorporating the prediction uncertainty of distributed PVs and active power transmission loss is constructed, which can be solved in real-time by Chebyshev graph convolutional network (ChebNet). In the lower level, given the electrical interaction between distributed PVs, the optimal active power tracking of the distributed PVs is realized through reference voltage and current tracking control. Further, a delay-dependent distributed coordinated $ H_{\infty }$ controller is designed to achieve stable tracking in the presence of communication delays and load perturbations. Finally, simulations are performed on the modified IEEE 33-bus and IEEE 118-bus test systems, and the results verify the effectiveness and superiority of ChebNet, as well as the good accuracy, tracking speed, and robustness of the proposed control method.
For the optimal power distribution problem of battery energy storage power stations containing multiple energy storage units, a grouping control strategy considering the wind and solar power generation trend is proposed. Firstly, a state of charge (SOC) consistency algorithm based on multi-agent is proposed. The adaptive power distribution among the units started can be realized using this algorithm. Then, considering the trend of wind and solar power generation, a reasonable grouping control strategy is formulated. The grouping situation of the units is determined by using the probability distribution characteristics of energy storage charging and discharging, which reduces the number of charging and discharging conversions and extends the power station life. Finally, the actual data of a wind–solar energy storage microgrid is used to verify the method. The simulation results demonstrate that the proposed method has certain advantages in terms of control effect, SOC consistency, and extending the power station life.