Vibration signal of wind turbine has the non‐linear and non‐stationary characteristic, thus it is difficult to extract the fault feature. In this study, a novel method based on variational mode decomposition (VMD) and Teager energy operator (TEO) is proposed to diagnose the bearing faults of wind turbine. First, vibration signal is decomposed into several intrinsic mode function (IMF) components by means of VMD, which is a recently proposed signal decomposition method. Then, the most sensitive IMF component is selected according to kurtosis criterion. Moreover, TEO is applied to the most sensitive IMF in order to highlight impact signal. Finally, spectrum is obtained by applying Fourier transform to Teager energy of the selected IMF, thus extracting the fault feature to diagnose bearing fault. The effectiveness of the proposed method for fault diagnosis is validated by simulation and experimental signal analysis results, and comparison studies show its advantage over empirical mode decomposition and conventional spectrum analysis for wind turbine bearing fault diagnosis.
15 August 2023 in IEEE Transactions on Instrumentation and Measurement
Short-term residential load forecasting (STRLF) is critical for safe and stable operation of the microgrid system. Due to shred conditions such as temperature and holiday impacts, households in the same region may exhibit similar consumption patterns. However, existing STRLF methods focus mainly on exploring the temporal patterns of a single household; the spatial correlations between multiple households are generally ignored. To address this challenge, a spatial and temporal attention-enabled transformer model, STformer, is proposed to extract the dynamic spatial and nonlinear temporal correlations between residential units and perform joint predictions of multivariate residential loads. The combination of improved temporal attention and spatial attention mechanisms allows the proposed method to capture complex spatial and temporal factors without prior geographical information. The Monte Carlo (MC) dropout method is utilized to further extend the proposed model to multi-task residential probabilistic load forecasting. Compared to Transformer, the proposed model improves the point forecast accuracy of individual New York and Los Angeles by 16.54% and 6.95%, respectively; and the combined point forecast accuracy by 22.46% and 11.86%. In addition, the proposed model improved the residential probabilistic load prediction accuracy by 10.21% and 11.07% in New York and Los Angeles, respectively, compared to SGPR.
As a new dynamic maintenance strategy, the condition-based opportunistic maintenance strategy for multi-component system is presented in this work. In the strategy, the degeneration of each component is described by Weibull proportional hazards model or Weibull proportional intensity model, and the condition indicator is defined to characterize the operating state of each component. Then, when and how to maintain a component can be confirmed by comparing the value of the condition indicator with that of the maintenance threshold function. Condition-based maintenance will be implemented on a component if the value of its condition indicator exceeds that of its condition-based maintenance threshold function. Meanwhile, opportunistic maintenance will also be implemented on a component if the value of its condition indicator exceeds that of its opportunistic maintenance threshold function. The two maintenance threshold functions can be determined by minimizing maintenance cost. Finally, taking the wind turbine as an example of a multi-component system, simulation analyses are described to validate the feasibility and effectiveness of the condition-based opportunistic maintenance strategy.
Lithium-ion batteries are widely used in power grids as a common form of energy storage in power stations. The state of charge (SOC) and state of health (SOH) reflect the capacity and lifetime variation in the Li-ion batteries, and they are important state parameters of Li-ion batteries. Therefore, the establishment of accurate SOC and SOH prediction models is an essential prerequisite for the correct assessment of the status of lithium batteries, the improvement of the operational accuracy of energy-storage stations, and the development of maintenance plans for energy-storage stations. This paper first analyzes the correlation between SOC and SOH, and then proposes a joint SOC and SOH prediction model using the particle swarm optimization (PSO) algorithm to optimize the extreme gradient boosting algorithm (XGBoost), which takes into account the dynamic correlation between SOC and SOH dynamics, thus enabling more accurate SOC and SOH prediction. Finally, the prediction model is validated using the Oxford battery aging dataset. The correlation between SOC and SOH is verified by comparing the joint prediction results with the SOC individual prediction results. Then, the prediction results of the PSO-XGBoost model, the traditional XGBoost model, and the long short-term memory neural network are compared to verify the effectiveness and accuracy of the PSO-XGBoost model.
To improve the neural network detection accuracy of the electric power bushings in infrared images, a modified algorithm based on the You Only Look Once version 2 (YOLOv2) network is proposed to achieve better recognition results. Specifically, YOLOv2 corresponds to a convolutional neural network (CNN), although its rotation invariance is poor, and some bounding boxes (BBs) exhibit certain deviations. To solve this problem, the standard Hough transform and image rotation are utilized to determine the optimal recognition angle for target detection, such that an optimal recognition effect of YOLOv2 on inclined objects (for example, bushing) is achieved. With respect to the problem that the BB is biased, the shape feature of the bushing is extracted by the Gap statistic algorithm, based on K-means clustering; thereafter, the sliding window (SW) is utilized to determine the optimal recognition area. Experimental verification indicates that the proposed rotating image method can improve the recognition effect, and the SW can further modify the BB. The accuracy of target detection increases to 97.33%, and the recall increases to 95%.
Energy efficiency evaluation of industrial park customers is carried out to help customers develop optimization strategies and improve the energy efficiency level. The evaluation indexes are proposed based on pressure-state-response (PSR) model and the redundant indexes are selected by combining principal component analysis (PCA) and correlation analysis. Thus the dynamic energy efficiency index system is constructed. The weight of indexes is calculated by the entropy weight method (EWM). An energy efficiency evaluation model based on improved Grey-technique for order preference by similarity to ideal solution (TOPSIS) is proposed, which replaces the Euclidean distance by weighted grey correlation degree and can accurately evaluate customers’ energy efficiency level. An energy efficiency optimization model is proposed, which can maximize optimization benefits while improving energy efficiency. The validity of the evaluation and optimization models is verified by the case study of an industrial park.