We experimentally investigate the time-dependent degradation of AlGaN/GaN metal–insulator–semiconductor high electron mobility transistors subjected to different bias conditions. By means of the combined performance under OFF/SEMI-ON/ON state bias conditions, the dependence of threshold voltage ( Vth ), maximum transconductance ( gm ) and saturation drain current ( Idsat ) on stress mode are revealed. In the OFF-state, with the high temperature reverse bias stress, the main mechanism is the charge-trapping in the gate dielectric layer, leading to the recoverable negative shift of the Vth . In the SEMI-ON-state, because of the hot-carrier injection, the hot electrons could break the Si–H bonds, resulting in the generation of interface states and can also be captured by the trap states in the AlGaN barrier or GaN buffer. This effect will cause the decrease of saturation drain current and an unrecoverable Vth negative shift. In the ON-state, due to the attenuation of hot electrons effect, Vth hardly changes, while Idsat has a dramatic decrease caused by the self-heating effect. Low frequency noise characteristics were used to extract the defect state density, which then increases by about three orders of magnitude after SEMI-ON-state stress.
Li[Ni0.885Co0.1V0.015]O2 (NCV), Li[Ni0.9Co0.1]O2 (NC), and Li[Ni0.885Co0.1Al0.015]O2 (NCA) nanoparticles are synthesized by means of oxalic acid co-precipitation with subsequent calcination. The evolution of Li-ion diffusion and deformation of both NCV and NCA under an external electric field are characterized by means of conductive atomic force microscopy and electrochemical strain microscopy. Macroscopic electrochemical characterization reveals that the Li-ion diffusivity in NCA is greater than that in NCV, and the undesirable irreversible H2–H3 phase transition occurs more readily in NCV than in NCA. The scanning probe microscopy results corroborate well with the macroscopic electrochemical measurements, which tell that vanadium and aluminum substitution can accelerate Li+ diffusion kinetics and enhance the reversibility of the H2–H3 phase transformation during the electrochemical process in varying degrees.
It has been experimentally observed that changes in the nanopore structure have a great impact on the ferroelectric domain structure, and then, the ferroelectric polarization value of the film can be controlled to increase the response of the electrocaloric effect. This phenomenon has great application prospects in refrigeration applications. In this study, the evolution process of the domain structure of porous ferroelectric films of Pb0.7 Sr0.3TiO3 (PST) with different pore shapes was obtained through phase field simulation, and the influence of the pore shape on the performance of electrocaloric was predicted and analyzed. The results show that different shapes of pores can control the magnitude of the adiabatic temperature change. Among them, the anisometric ellipse shaped pore thin film can obtain a maximum adiabatic temperature change of 8 K, which is a significant improvement compared with traditional PST ceramics and PST non-porous films. This large adiabatic temperature change is due to the pore-induced domain switching. Therefore, controlling the pore shapes provides a new idea for optimizing the electrocaloric properties of porous ferroelectric thin films.