Application of the hot stamping process on heat-treatable aluminum alloys effectively solves the problems of large springback and poor ductility during forming at room temperature, which expands the range of applications of aluminum alloys in the transportation industry. Sheet heating plays an important role in the hot stamping process, and increasing the heating rate can improve the hot stamping efficiency to some extent. In this paper, the feasibility of applying contact heating techniques with higher heating rates in the hot stamping process was studied. A contact heating device was designed, and the temperature distribution of the device contact surface was observed. Furthermore, the heating characteristics of 7075 aluminum alloy sheets during the contact heating process were explored by experiments and finite element simulation. Finally, the rapid solution treatment of aluminum alloy was carried out with a contact heating device, which was compared with the furnace heating solution treatment. The experimental and simulation results indicate that the device contact surface has a relatively uniform temperature distribution, and the aluminum alloy sheets can be heated to close to the set temperature in 15 s using contact heating techniques. Meanwhile, the rapid solution treatment of aluminum alloy sheets can be achieved within 15–20 s by contact heating techniques, obtaining superior mechanical properties. This suggests that the contact heating process can be used for rapid heating and rapid solution treatment of aluminum alloy sheets in hot stamping process.
The application of the quenching and partitioning (Q-P) process on advanced high-strength steels improves part ductility significantly with little decrease in strength. Moreover, the mechanical properties of high-strength steels can be further enhanced by the stepping-quenching-partitioning (S-Q-P) process. In this study, a two-stage quenching and partitioning (two-stage Q-P) process originating from the S-Q-P process of an advanced high-strength steel 30CrMnSi2Nb was analyzed by the simulation method, which consisted of two quenching processes and two partitioning processes. The carbon redistribution, interface migration, and phase transition during the two-stage Q-P process were investigated with different temperatures and partitioning times. The final microstructure of the material formed after the two-stage Q-P process was studied, as well as the volume fraction of the retained austenite. The simulation results indicate that a special microstructure can be obtained by appropriate parameters of the two-stage Q-P process. A mixed microstructure, characterized by alternating distribution of low carbon martensite laths, small-sized low-carbon martensite plates, retained austenite and high-carbon martensite plates, can be obtained. In addition, a peak value of the volume fraction of the stable retained austenite after the final quenching is obtained with proper partitioning time.