Rim seal structures and sealing flows are essential in aero engines for preventing hot gas ingestion from mainstream to turbine disk cavities. A novel design method of rim sealing flow path based on auxiliary sealing holes and sealing air re-distributions has been proved to improve sealing effectiveness. The present paper uses this method to re-design the axial rim sealing flow in a high-pressure turbine front cavity in an engine turbine. The incidence angle of the auxiliary sealing air has been proved to have a significant influence on sealing performance. Three different incidence angles, 0-deg, 35-deg, and 70-deg, with the maximum angle close to the vane exit flow angle, are investigated using unsteady computational fluid dynamics methods validated by experimental data. Sealing effectiveness, swirl ratio, unsteady flow structures in both rim clearance and wheel space cavity are considered. The auxiliary sealing air with a swirl in the circumferential direction is proved to improve and uniform swirl ratio and suppress flow instabilities. This results in a reduction in hot gas ingestion and a considerable improvement in sealing effectiveness. The mechanisms of improving sealing effectiveness using this novel method are explained. The conclusions may support the understanding of the complex flow mechanisms near the rim seal, provide references for the design of this novel structure and give possibilities to improve rim seal performance and engine efficiency.
This paper investigates the complex flow characteristics and parameter prediction methods for axial-inlet cover-plate cavities in pre-swirl systems numerically. Using a full-annulus three-dimensional computational model, the flow mechanisms of cover-plate cavities are compared between axial and radial inlet configurations. The analysis reveals that the axial-inlet configuration exhibits intensified non-axisymmetric vortex pairs in the low-radius region due to axial inflow inertia. These vortex structures enhance radial angular momentum exchange, leading to a substantial inlet angular momentum deficit that consequently reduces swirl ratios and pressure coefficients relative to the radial-inlet configuration. Furthermore, parametric studies demonstrate that small gap ratio amplifies circumferential flow non-uniformity through strong impingement effects, while elevated inlet swirl ratio significantly extends the source region boundary by strengthening centrifugal forces. To address the prediction discrepancies in existing models, this work proposes a modified correlation for the effective inlet swirl ratio that account for the inlet momentum loss and develops a new predictive model for the edge of source region incorporating centrifugal effects. These physics-based corrections, validated against simulation data, significantly improve the prediction accuracy for axial-inlet cover-plate cavities compared to conventional models.
*Hot gas ingestion into the wheel space can reduce the lifetime of vulnerable components in gas turbine such as turbine disk. Rim seal structure at the periphery of the wheel-space is designed to protect the turbine disk from hot gas. This paper describes the steady and unsteady Reynolds-averaged Navier-Stokes (RANS and URANS) computation method with Shear Stress Transport (SST)
Gas turbines, as a power generating machine, are widely used in the world today. The overall thermal efficiency of gas turbine is strongly dependent on the inlet temperature of the turbine. As the turbine inlet temperature increases, the problem of hot mainstream gas ingestion arises. Hot gas ingestion refers to the phenomenon of the mainstream hot gas ingests into the wheel space