Dirk Naujoks

Dr. Dirk Naujoks


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 August 2021 in Nuclear Fusion
Verified
Journal Article
Open access
PDF file
MJM. Jakubowski
M. Jakubowski
MEM. Endler
M. Endler
YFY. Feng
Y. Feng
YGYu Gao
Yu Gao
CKC. Killer
C. Killer
TTthe W7-X Team
the W7-X Team
Wendelstein 7-X (W7-X), the largest advanced stellarator, is built to demonstrate high power, high performance quasi-continuous operation. Therefore, in the recent campaign, experiments were performed to prepare for long pulse operation, addressing three critical issues: the development of stable detachment, control of the heat and particle exhaust, and the impact of leading edges on plasma performance. The heat and particle exhaust in W7-X is realized with the help of an island divertor, which utilizes large magnetic islands at the plasma boundary. This concept shows very efficient heat flux spreading and favourable scaling with input power. Experiments performed to overload leading edges showed that the island divertor yields good impurity screening. A highlight of the recent campaign was a robust detachment scenario, which allowed reducing power loads even by a factor of ten. At the same time, neutral pressures at the pumping gap entrance yielded the particle removal rate close to the values required for stable density control in steady-state operation.

2 December 2021 in Nuclear Fusion
Verified
Journal Article
Open access
SBS. Brezɩnsek
S. Brezɩnsek
CDC.P. Dhard
C.P. Dhard
MJM. Jakubowski
M. Jakubowski
RKR. König
R. König
SMS. Masuzaki
S. Masuzaki
TTthe W7-X Team
the W7-X Team
W7-X completed its plasma operation in hydrogen with island divertor and inertially cooled test divertor unit (TDU) made of graphite. A substantial set of plasma-facing components (PFCs), including in particular marker target elements, were extracted from the W7-X vessel and analysed post-mortem. The analysis provided key information about underlying plasma–surface interactions (PSI) processes, namely erosion, transport, and deposition as well as fuel retention in the graphite components. The net carbon (C) erosion and deposition distribution on the horizontal target (HT) and vertical target (VT) plates were quantified and related to the plasma time in standard divertor configuration with edge transform ι = 5/5, the dominant magnetic configuration of the two operational phases (OP) with TDU. The operation resulted in integrated high net C erosion rate of 2.8 mg s−1 in OP1.2B over 4809 plasma seconds. Boronisations reduced the net erosion on the HT by about a factor 5.4 with respect to OP1.2A owing to the suppression of oxygen (O). In the case of the VT, high peak net C erosion of 11 μm at the strike line was measured during OP1.2B which converts to 2.5 nm s−1 or 1.4 mg s−1 when related to the exposed area of the target plate and the operational time in standard divertor configuration. PSI modelling with ERO2.0 and WallDYN-3D is applied in an interpretative manner and reproduces the net C erosion and deposition pattern at the target plates determined by different post-mortem analysis techniques. This includes also the 13C tracer deposition from the last experiment of OP1.2B with local 13CH4 injection through a magnetic island in one half module. The experimental findings are used to predict the C erosion, transport, and deposition in the next campaigns aiming in long-pulse operation up to 1800 s and utilising the actively cooled carbon-fibre composite (CFC) divertor currently being installed. The CFC divertor has the same geometrical design as the TDU and extrapolation depends mainly on the applied plasma boundary. Extrapolation from campaign averaged information obtained in OP1.2B reveals a net erosion of 7.6 g per 1800 s for a typical W7-X attached divertor plasma in hydrogen.

12 April 2023 in Plasma Physics and Controlled Fusion
Verified
Journal Article
Open access
PDF file
VHVictoria Haak
Victoria Haak
SBSergey A Bozhenkov
Sergey A Bozhenkov
YFYuhe Feng
Yuhe Feng
AKAmit Kohinoor Kharwandikar
Amit Kohinoor Kharwandikar
TKThierry Kremeyer
Thierry Kremeyer
UWUwe Wenzel
Uwe Wenzel
During the first test divertor campaign of the stellarator experiment Wendelstein 7-X (Pedersen et al 2022 Nucl. Fusion 62 042022), OP1.2b, 13 neutral gas pressure gauges collected data in different locations in the plasma vessel, enabling a detailed analysis of the neutral gas pressures, the compression ratios and the particle exhaust rates via the turbomolecular pumps in the different magnetic field configurations. In Wendelstein 7-X, the edge magnetic islands are intersected by the divertor target plates and used to create a plasma-wall interface. As the number and position of the magnetic islands varies in different magnetic field configurations, the position of the strike line on the target plates and thus the neutral gas pressure in the subdivertor differs between the configurations. Neutral gas pressures on the order of few 10−4 mbar were measured in the subdivertor region. The highest neutral gas pressure of 1.75 × 10 − 3 mbar was obtained in the so-called high iota configuration featuring four edge magnetic islands per cross section. The neutral particle flux through the pumping gaps into the subdivertor volume was provided by EMC3-EIRENE simulations and allowed to analyze the relation between the particle flux entering the subdivertor and the pressure distribution in the subdivertor. Finite element simulations in ANSYS provide a detailed picture of the pressure distribution in the subdivertor volume and agree with the neutral gas pressure measurements in the subdivertor in the standard configuration featuring an island chain of 5 edge magnetic islands. Surprisingly high neutral gas pressures that were not predicted by the simulation were measured in the subdivertor region away from the main strike line for discharges in the most used magnetic configuration, the standard configuration. While the pressure ratio between the two sections of the subdivertor volume, the low and high iota section is 0.06 in high iota configuration, a ratio of 2–5 was obtained in the other configurations, indicating significant particle loads and exhaust rates on the high iota section of the subdivertor in magnetic configurations with the main strike line on the low iota divertor targets.

5 August 2022 in Nuclear Fusion
Verified
Journal Article
Open access
PDF file
UWU. Wenzel
U. Wenzel
GSG. Schlisio
G. Schlisio
PDP. Drewelow
P. Drewelow
MKM. Krychowiak
M. Krychowiak
RKR. König
R. König
TTthe W7-X Team
the W7-X Team
The optimized superconducting stellarator Wendelstein 7-X (W7-X) is equipped with an island divertor for energy control and efficient pumping. We investigated the performance of the island divertor in terms of gas exhaust. For this purpose we have installed 18 pressure gauges in the vacuum vessel. This allowed us to determine the exhaust efficiency, the leakage, the collection efficiency and the compression ratio of the island divertor. These quantities depended strongly on the magnetic configuration. The best performance was obtained in the high-iota configuration. The exhaust efficiency was 2.9%, significantly higher than in the standard configuration (0.44%), and the maximum neutral compression was about 80. The high-iota configuration appears particularly promising for long-pulse operation of W7-X.

27 November 2023 in Plasma Physics and Controlled Fusion
Verified
Journal Article
Open access
PDF file
DBDieter Boeyaert
Dieter Boeyaert
YFYuhe Feng
Yuhe Feng
HFHeinke Frerichs
Heinke Frerichs
TKThierry Kremeyer
Thierry Kremeyer
DNDirk Naujoks
Dirk Naujoks
UWUwe Wenzel
Uwe Wenzel
This paper analyzes the neutral fluxes in the divertor region of the W7-X standard configuration for different input powers, both under attached and detached conditions. The performed analysis is conducted through EMC3-EIRENE simulations. They show the importance of the horizontal divertor to generate neutrals, and resolve the neutral plugging in the divertor region. Simulations of detached cases show a decrease in the number of generated neutrals compared to the attached simulations, in addition to a higher fraction of the ion flux arriving on the baffles during detachment. As the ionization takes place further inside the plasma during detachment, a larger percentage of the generated neutral particles leave the divertor as neutrals. The leakage in the poloidal and toroidal direction increases, just as the fraction of collected particles at the pumping gap. The fraction of pumped particles increases with a factor two, but stays below one percent. This demonstrates that detachment with the current target geometry, although it improves the power exhaust, is not yet leading to an increased particle exhaust.

17 February 2021 in Nuclear Fusion
Verified
Journal Article
Closed access
PDF file
GSGeorg Schlisio
Georg Schlisio
UWU. Wenzel
U. Wenzel
DNDirk Naujoks
Dirk Naujoks
TPThomas Sunn Pedersen
Thomas Sunn Pedersen
HGHeinz Grote
Heinz Grote
KBKai Jakob Brunner
Kai Jakob Brunner
The investigation of fuel retention in fusion experiments is important in view of plasma density control as well as tritium inventory for future fusion reactors. We present a first gas balance of the stellarator Wendelstein 7-X with its inertially cooled graphite divertor. The gas balance is used to estimate the wall inventory and it is found that the wall plays an important and dynamic role, absorbing or releasing particles depending on the plasma conditions. Several different scenarios are presented and the effect of fueling and heating on the wall inventory is assessed. We find that the record duration plasma experiment of 100 s required previous shorter plasmas to be successfully conducted.