Compared with onshore wind turbine, the offshore wind turbine is more easily destroyed influenced by the complicated conditions at sea. In this study, a refined finite element model of offshore wind turbine in consideration of the soil-structure interaction is built. The dynamic response of the wind turbine tower in different water depths is investigated; then the weak positions of the wind turbine tower under earthquake is determined. We found that the water pressure on one side of the inflow face of pile foundation is the greatest; as the rate of flow increases, the negative water pressure on the contact surface increased more than the positive water pressure. The maximum displacement of the structure influenced by dynamic water pressure is located at the tower top, the maximum equivalent stress strain is located at two-thirds of the tower height, and the maximum bending moment appears at the bottom of the tower. When the water depth increases from 0 m to 5 m, the displacement and bending moment of wind tower structure increased by 29 % and 25 % respectively under the influence of dynamic water pressure; thus the influence of dynamic water pressure on the dynamic response of the structure should be paid attention to. Finally, the shaking table test of the wind turbine is conducted; the test results are compared with the numerical simulation results, and feasibility of the numerical simulation method was verified.
Vs30 (equivalent shear-wave velocity of soil layers within a depth of 30 m underground) is widely used in the field of seismic engineering; however, due to the limitation of funds, time, measuring devices, and other factors, the depth for testing shear-wave velocity in an engineering site rarely reaches 30 m underground. Therefore, it is necessary to predict Vs30 effectively. We analyzed the existing models using 343 boreholes with depths greater than 30 m in Tangshan, China. It shows that the topographic slope method is not suitable for predicting Vs30 in Tangshan. The Boore (2011) model overestimates, while Boore (2004) underestimates Vs30 in Tangshan, while Junju Xie’s (2016) model has ideal prediction results. We propose three new models in this paper, including the bottom constant velocity (BCV) model, linear model, and conditional independent model. We find that the BCV model has limited prediction ability, and the linear model is more suitable when z ≤ 18 m, while the conditional independent model shows good performance under conditions where z > 18 m. We propose that the model can be accurately and effectively applied in Tangshan and other regions with low shear-wave velocity.
1 January 2020 in Latin American Journal of Solids and Structures
Because soluble salt in saline soil dissolves with water, utility tunnels built in saline soil foundation are more likely to damage due to by groundwater and earthquake. In this study, new cementitious composite materials were developed by using slag, building gypsum, quicklime, and magnesia. The unconfined compressive strengths of the saline soil solidified by new cementitious composite materials and cement are investigated, and the optimum proportion of the different components of the new cementitious composite materials is determined. We found from microscopic characteristics of the saline soil solidified by the new cementitious composite materials and cement that the new materials could better absorb chloride ions. Finally, the new cementitious composite materials were applied to saline soil foundation reinforcement of a utility tunnel. By using the finite element method (FEM) and shaking table tests, it can be seen that the displacement, acceleration and extent of damage of the utility tunnel after saline soil foundation reinforcement using new cementitious composite materials significantly decreased; therefore, the new cementitious composite materials can improve the seismic behaviour of the utility tunnel and shows potential future engineering application value.
11 March 2025 in Bulletin of Engineering Geology and the Environment
The November 22, 2014, Kangding strike-slip earthquake (Mw 6.0) occurred on the Southern Section of the Xianshuihe Fault Zone. Its epicenter was at 101.69°E, 30.26°N, source mechanism strikes N33°E, dips 82°, and slipped at an angle of –9°. In this work, we simulated ground motions by the stochastic finite-fault model(SFFM), including peak ground acceleration, peak velocity, and acceleration time-histories caused by this earthquake.
21 March 2026 in Soil Dynamics and Earthquake Engineering