Cold atmospheric plasma (CAP) enhances uptake and accumulation of nanoparticles and promotes synergistic cytotoxicity against cancer cells. However, the mechanisms are not well understood. In this study, we investigate the enhanced uptake of theranostic nanomaterials by CAP. Numerical modelling of the uptake of gold nanoparticle into U373MG Glioblastoma multiforme (GBM) cells predicts that CAP may introduce a new uptake route. We demonstrate that cell membrane repair pathways play the main role in this stimulated new uptake route, following non-toxic doses of dielectric barrier discharge CAP. CAP treatment induces cellular membrane damage, mainly via lipid peroxidation as a result of reactive oxygen species (ROS) generation. Membranes rich in peroxidised lipids are then trafficked into cells via membrane repairing endocytosis. We confirm that the enhanced uptake of nanomaterials is clathrin-dependent using chemical inhibitors and silencing of gene expression. Therefore, CAP-stimulated membrane repair increases endocytosis and accelerates the uptake of gold nanoparticles into U373MG cells after CAP treatment. We demonstrate the utility of CAP to model membrane oxidative damage in cells and characterise a previously unreported mechanism of membrane repair to trigger nanomaterial uptake. This knowledge will underpin the development of new delivery strategies for theranostic nanoparticles into cancer cells.

The use of plastics has spanned across almost all aspects of day to day life. Although their uses are invaluable, they contribute to the generation of a lot of waste products that end up in the environment and end up polluting natural habitats such as forests and the ocean. By treating low-density polyethylene (LDPE) samples with non-thermal plasma in ambient air and with an addition of ≈4% CO₂, the biodegradation of the samples can be increased due to an increase in oxidative species causing better cell adhesion and acceptance on the polymer sample surface. It was, however, found that the use of this slight addition of CO₂ aided in the biodegradation of the LDPE samples more than with solely ambient air as the carbon bonds measured from Raman spectroscopy were seen to decrease even more with this change in gas composition and chemistry. The results show that the largest increase of polymer degradation occurs when a voltage of 32 kV is applied over 300 s and with a mixture of ambient air and CO₂ in the ratio 25:1.

A large gap pin‐to‐plate, atmospheric‐pressure plasma reactor is demonstrated as means of in vitro study of plasma species interactions with cell cultures. By employing optical emission and optical absorption spectroscopy, we report that the pin‐to‐pate plasma array had an optimal discharge frequency for cell death of 1000 Hz in ambient air for the target cancer cell line, human glioblastoma multiform (U‐251MG). The detected plasma chemistry contained reactive oxygen and nitrogen species including OH, N₂, N₂⁺ and O₃. We show that by varying the plasma discharge frequency, the plasma chemistry can be tailored to contain up to 8.85 times higher levels of reactive oxygen species (ROS) as well as a factor increase of up to 2.86 for levels of reactive nitrogen species (RNS). At higher frequencies, ROS are more dominant than RNS, which allows for a more dynamic and controlled environment for sample study without modifying the inducer gas conditions. When used for treatment of culture media and cell cultures, variation of the plasma discharge frequency over the range 1000–2500 Hz demonstrated a clear dependence of the responses, with the highest cytotoxic responses observed for 1000 Hz. We propose that the reactor offers a means of studying plasma–cell interactions and possible cofactors such as pro‐drugs and nanoparticles for a large volume of samples and conditions due to the use of well plates.

Numerous electrode geometries and power supplies, both commercial and in-house, have been employed for the generation of low-temperature atmospheric plasma jets. In this work, the development and operation of a 12 jet nonthermal atmospheric plasma system is presented. The study is based on optical spectroscopy as a diagnostic method due to its nonintrusive nature. A key focus of this study was the material selection (conductive and nonconductive), with several polymers screened for the jet design leading to polyacetal as the choice material. Their results are compared with other atmospheric plasma jet systems. The results show a significant increase in residence time and the spatial homogeneity for ambient air's main species, including: OH, O I, O2, O3, N2, and N2+. Their densities are studied with respect to treatment time, distance, duty cycle, and discharge frequency, as well as the jets' carrier gas chemistries (argon and helium). For their plasma jet system, the bulk of the chemical reactions occur in the surrounding atmosphere and not in the jet nozzle, which is different from most other plasma jet systems. The electron energy distribution function, for the given chemistries, is also reported.