Deep and ultra-deep reservoirs are widely regarded as a major substitute in onshore oil and gas exploration and development. These reservoirs typically exhibit significant geo-stress sensitivity and strong heterogeneity due to the co-existence of tight matrix and multi-scale fractures, resulting in more complicated oil-water flow patterns in deformed multi-scale media and greater challenges in enhancing hydrocarbon recovery. In order to investigate the underlying oil-water flow mechanisms in deformed multi-scale fracture-porous media, the in situ stress-loading computed tomography scanning experiment for a typical deep rock sample is conducted and three-dimensional digital rock models under different stress-loading conditions are thereafter reconstructed. By introducing a multi-relaxation color-gradient lattice Boltzmann model, immiscible viscous fingering and its effect of fluid interface evolution in deformed multi-scale fracture-porous media of deep rock samples are ultimately simulated. The results show that deformation of rock microstructure caused by stress variation can greatly affect immiscible displacement pattern. These effects are primarily characterized by pore morphology of invading phase, number of viscous fingerings and immiscible displacement efficiency. During the deformation of the core, the displacement patterns are dominated by viscous fingering, accompanied by multiple Haines jump events. The invading phase that leaves from oil-water front due to Haines jump can rapidly migrate along preferential flow paths. As the injection distance increases, the number of viscous fingerings in the deep sandstone core initially increases and then decreases. After failure, the invading phase advances rapidly along the fracture, filling larger pores in the preferential flow paths, resulting in a significant improvement in displacement efficiency.
In the late high water cut stage of medium- and high-permeability sandstone reservoirs, remaining oil becomes highly dispersed, and rational optimization of the water injection rate is crucial for further recovery improvement. However, a quantitative relationship between pore-scale remaining oil mobilization and macroscopic displacement efficiency is still lacking, limiting mechanistic guidance for field-scale rate optimization and water cut control. To address this issue, variable-rate waterflooding experiments were conducted on medium- and high-permeability sandstone cores to establish the relationships among displacement rate, injected pore volume multiples, and oil displacement efficiency and to identify the optimal rate. In addition, an X-CT-based heterogeneous pore-scale geometric model and a series of idealized pore-throat models were used for oil–water two-phase flow simulations. Combined with an orthogonal experimental design, the effects of displacement rate, wettability, oil viscosity, interfacial tension, and pore structure parameters on remaining oil mobilization and displacement efficiency were systematically evaluated. The results indicate an optimal displacement rate of 2–3 mL/min. At low rates, remaining oil cannot be effectively mobilized, whereas excessively high rates intensify fingering and channeling along high-capacity pathways, reducing the final displacement efficiency. Simulations further show that a moderate rate increase markedly lowers remaining oil saturation, while overly high rates induce severe channeling. Orthogonal analysis reveals that displacement rate and wettability are the dominant factors, with normalized weights of 46.3% and 30.5%, respectively. Larger pore diameters, smaller pore-throat ratios, and higher coordination numbers reduce mobilization pressure and remaining oil saturation. This work elucidates pore-scale remaining oil mobilization kinetics under variable-rate waterflooding and provides a quantitative microscopic basis for rate optimization and fine-scale remaining oil exploitation in mature waterfloods.