26 June 2017 in IEEE Transactions on Circuits and Systems I: Regular Papers
In this paper, a novel thermoelectric energy harvesting system with a reconfigurable array of thermoelectric generators (TEGs), which requires neither an inductor nor a flying capacitor, is proposed. The proposed architecture can accomplish maximum power point tracking (MPPT) and voltage conversion simultaneously via the reconfiguration of the TEG array, and demonstrate significantly improved power conversion efficiency over the conventional switching converter and switched-capacitor architectures. Two systematical scaling approaches- powers-of-two scaling and maximum-factor scaling-are presented and analyzed to serve as the design guideline, catering for reconfigurable TEG arrays of different sizes. In order to optimize the chip area required, a custom-designed, multi-level hierarchy and systematically scalable switch array that requires a reasonable number of switches is also developed to enable the reconfiguration of the TEG array. The 16-node and 12-node versions of the proposed system have been implemented in a standard 0.35-μm CMOS process. Measurement results verify the analysis, and confirm that the proposed system can maintain a higher than 88.8% efficiency over a wide range of temperature gradients.
4 February 2022 in IEEE Transactions on Circuits and Systems I: Regular Papers
This paper presents a gate driver for a GaN-based half-bridge structure operating in a buck converter with input voltage >40 V or a boost converter with output voltage >30 V. Two 500 pF on-chip capacitors are utilized to construct three-level gate drivers, providing a near- $V_{{\text {DD}}}$ negative voltage for gate of the rectifier switch to eliminate the induced pulse on the gate from the high dv / dt slew rate of $V_{\text {X}}$ when the main switch is turned on. The dead time controller tunes the delay of the gate signal of the rectifier switch by sensing the slope of $V_{\text {X}}$ , thus the near-optimal zero-voltage switching can be achieved with deviation < 3 ns. The GaN driver is implemented with a 0.18- $\mu \text{m}$ BCD process. The efficiencies can be improved by 8.33% and 6.87% at light load in a buck and a boost converter due to the dead-time control. The peak efficiencies of 20 V–12 V and 12 V–18 V conversions are 86.37% and 84.39%, respectively.
3 May 2021 in IEEE Transactions on Power Electronics
This paper presents an adaptively-biased output-capacitor-free LDO regulator with pole-tracking-compensation for wearable biomedical electronics. The proposed LDO consists of a supply-ripple subtraction reference buffer which enhances PSR from -26.4dB to -67.4dB at 1MHz. The total quiescent current is 8.6A at no load, and the current efficiency is 98.8% at full load. Designed and fabricated in a 0.18m CMOS process, the prototype silicon area is 0.0113mm2.
1 July 2020 in Journal of Alloys and Compounds
13 February 2017 in IEEE Journal of Solid-State Circuits
This paper presents a novel switching-converter-free ac-dc light-emitting diode (LED) driver with low-frequency-flicker reduction for general lighting applications. The proposed driving solution can minimize the system size as it enables the monolithic integration of the controller and power transistors while both the bulky off-chip electrolytic capacitors and magnetics are eliminated. Moreover, the driver can effectively reduce the harmful optical flicker at the double-line-frequency by employing a novel quasi-constant power control scheme while maintaining high efficiency and a good power factor (PF). The proposed driver is implemented with a single controller integrated circuit chip, which includes the controller and high-voltage power transistors, and the off-chip diode bridge and valley-fill circuit. The chip is fabricated with a 0.35-μm 120-V high-voltage CMOS process and occupies 1.85 mm 2 . The driver can provide up to 7.8-W power to the LED and achieves 87.6% peak efficiency and an over 0.925 PF with only 17.3% flicker from a 110-V ac 60-Hz input.
3 May 2022 in IEEE Solid-State Circuits Letters
This letter presents an output-capacitor-free cascaded 2-power-transistor low-dropout (2-PT LDO) regulator with ultra-high power supply rejection (PSR) and fast transient response for low-power biomedical system-on-chips. The proposed 2-PT LDO consists of two stages in series, and the total dropout voltage is 200mV. In order to boost the total PSR in a wide frequency range, different PSR enhancement strategies are adopted in each stage and a reversed-phase supply-ripple-cancellation technique is provided by a proposed reference buffer to further improve the PSR performance. Furthermore, adaptive biasing with robust frequency compensation is utilized to maintain system stability with fast transient response. Designed and fabricated in a 0.18μm CMOS process, the active area is only 0.0237mm2. With the input voltage of 1.1-1.2V, the 2-PT LDO supplies 0.9-1 V with a total quiescent current of 24.2μA at no-load current. Experimental results show that PSR is better than -95dB up to 100 kHz.