The aim was to evaluate the shear-bond strength (SBS) of experimental short fiber-reinforced CAD/CAM composites (SFRC-CAD) and commercial CAD/CAM composites (Cerasmart 270) to different luting resin composites before and after hydrothermal aging. Discs (2 mm) obtained from SFRC-CAD and Cerasmart 270 were air-particle abraded and treated with a primer (G-CEM One Enhancing Primer) with or without universal adhesive (G2 Bond). A fiber-reinforced flowable composite (everX Flow) and a self-adhesive resin cement (G-CEM One) were used as luting materials under direct or indirect curing conditions. Thirty-two experimental groups were determined based on restorative material, bonding protocol, luting resin, curing technique, and aging procedure (n = 8/group). SBS was measured after 24 h of water storage or following hydrothermal aging. Data were analyzed using nonparametric statistical tests (p < 0.05). No statistically significant differences in SBS were observed between everX Flow and G-CEM One regardless of the bond application (p > 0.05). SFRC-CAD bonded with everX Flow and universal adhesive demonstrated significantly higher SBS than the corresponding Cerasmart groups (p < 0.05), whereas no significant differences were observed between comparable groups when G-CEM One was used. Failure mode analysis showed predominantly adhesive and mixed failures, with no cohesive failures within SFRC-CAD. Overall, the everX Flow proved to be an effective luting material, indicating that this material may be suitable for luting CAD/CAM indirect restorations.
Evaluating the shear bond strength (SBS) of contemporary universal adhesive systems on different substrates is critical for understanding their clinical applicability. In this study, the SBS of universal adhesives was assessed on 144 human and bovine tooth specimens, comparing enamel and dentin across etch-and-rinse and self-etch protocols. Following single-step or two-step adhesive application and resin cementation, the specimens were subjected to 5000 thermocycles before being evaluated with a universal testing machine. Failure modes and surface morphology were additionally characterized using stereomicroscopy and scanning electron microscopy (SEM). Statistical analyses revealed that both tissue type (p = 0.043) and tooth type (p < 0.001) significantly influenced SBS, while the main effect of the adhesive protocol was not significant (p = 0.485). A significant interaction occurred between tissue type and adhesive protocol (p = 0.013); Post hoc analyses revealed that Group A enamel had significantly higher bond strength than both Group D enamel (p = 0.026) and Group A dentin (p = 0.001). Observed failures were predominantly adhesive or mixed, and SEM confirmed expected acid-induced surface roughness. Human teeth yielded higher bond strengths than bovine teeth, meaning absolute SBS values from bovine lab studies should be used with caution.