With the escalating demand for advanced and eco-friendly processing technologies in mining engineering, the potential applications of microwave heating technology in the treatment of cement tailings backfill (CTB) are expanding significantly. This research comprehensively investigates the mechanisms through which microwave irradiation duration and power influence the mechanical properties of CTB with varying concentrations and cement-to-sand ratios. The aim is to reveal the influencing patterns through experimental methods, providing scientific evidence for optimizing CTB treatment processes. This paper conducted microwave heating tests, uniaxial compression tests, and SEM-EDS tests on CTB. The research results indicate that heating time and power significantly enhance the early strength of CTB, with a more pronounced effect on CTB with higher concentrations and higher cement–sand ratios. When the heating time is 7 min and the heating power is 340 W, the cement hydration reaction is maximally promoted, thereby increasing the density and strength growth rate of CTB. However, excessively long heating time or overly high heating power may cause microcracks or thermal stress concentration within the CTB, adversely affecting the strength growth rate of CTB. Optimal thermal exposure duration and microwave power settings facilitate the activation of cementitious materials and the nucleation of calcium-silicate-hydrate (C-S-H) phases, thereby accelerating the compressive strength evolution of cemented tailings backfill (CTB). The outcomes of this research offer valuable insights into the deployment of microwave heating methodologies in underground mine backfilling, which are pivotal for augmenting the economic viability and environmental sustainability of mining operations.
Prior to being released, the top coal of a fully mechanized caving face typically experiences the effects of mining-induced pressure and disturbances from the hydraulic support’s canopy. To investigate the promoting effect of canopy disturbances in the support-controlled area on the damage of top coal during fully mechanized top-coal caving mining, block instability theory and discrete block numerical simulation methods were employed. The instability modes during the initial support and cyclic disturbance stages were analyzed. The fracture evolution and displacement distribution curves were studied for coal bodies with strengths of 3.1 MPa, 15.0 MPa, and 29.5 MPa under the mining influence and support strengths of 0.5 MPa, 1.0 MPa, and 1.5 MPa during the initial support and cyclic disturbance processes. The results showed that during the initial support stage, the instability of the block-structured coal body exhibited four modes as follows: inter-block breakage, inter-block delamination, intra-block fracture expansion, and inter-block sliding. During the cyclic disturbance stage, the coal body instability showed three modes as follows: inter-block sliding, intra-block fracture expansion, and inter-block rotation. The disturbance from the support had little impact on the fragmentation of both low-strength and high-strength coal bodies. However, small support forces combined with multiple cycles of disturbance had an enhancing effect on the instability of medium-strength block-structured top coal.
The purpose of this study was to investigate the effect of the use of rubber powder from tire recovery on the dynamic loading performance of CPB. Finally, it is concluded that using recycled rubber material to backfill mine paste is helpful in reducing waste tire pollution and improving the impact resistance of the backfill body. The dynamic compressive strength, Dynamic Increase Factor (DIF), peak dynamic load strain, and dynamic load elastic modulus of the samples composed of slag, Portland cement, wastewater, and rubber powder were determined. Through the analysis of the experimental data, it can be seen that the recycled rubber reduces the dynamic compressive strength and DIF of the specimen but increases the peak dynamic load strain and dynamic load elastic modulus and other characteristics, and enhances the ability of the filled body to absorb elastic strain energy. The results show that recycled rubber can increase the deformation ability of the filler and improve the impact resistance of the filler. The results of this study provide valuable information and industrial applications for the effective management of solid waste based on sustainable development and the circular economy.