Wakana Takeuchi

Dr. Wakana Takeuchi

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 February 2020 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
WTWakana Takeuchi
Wakana Takeuchi
KKKatsuhiro Kutsuki
Katsuhiro Kutsuki
EKEiji Kagoshima
Eiji Kagoshima
TOToru Onishi
Toru Onishi
SIShinya Iwasaki
Shinya Iwasaki
ONOsamu Nakatsuka
Osamu Nakatsuka
We investigated the impact of the mechanical uniaxial strain on the inversion channel mobility of lateral n-channel metal-oxide-semiconductor field-effect transistor (MOSFET) on 4H-SiC(0001). We used custom-designed bend-holders to apply a tensile and compressive stress to the chip after MOSFET fabrication. The behavior of mobility with the two different channel directions 11 2 ¯ 0 and 1 1 ¯ 00 was investigated on the bend directions 11 2 ¯ 0 and 1 1 ¯ 00 with the tensile and compressive stress. We found that the inversion channel mobility effectively increases with the uniaxial compressive stress of the perpendicular configuration which is the drain current flow perpendicular to the bend direction. From the temperature dependence of mobility, we deduced that the enhancement of mobility is attributed to the reduction of the effective mass in 4H-SiC by introduced stress.

14 November 2022 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
KOKoki Ono
Koki Ono
TKTakashi Koide
Takashi Koide
KIKenji Ishikawa
Kenji Ishikawa
HTHiromasa Tanaka
Hiromasa Tanaka
博近博基 近藤
博基 近藤
WTWakana Takeuchi
Wakana Takeuchi
Silicon carbide (SiC) was coated onto carbon nanowall (CNW) scaffolds using chemical vapor deposition with a vinylsilane precursor at 700 °C to investigate the influence of the wall edge width, wall-to-wall distance, and surface morphology. The wall edge width ranged from 10 nm to those filling the wall-to-wall space without disrupting the CNW morphology. When SiC-coated CNWs (SiC/CNWs) were used as scaffolds for cell culture, cell viability increased until the edge area ratio reached 40%. In over 40% of edge area ratio, cell viability was saturate and comparable to flat surfaces such as SiC films on the Si substrate (SiC/Si) and control samples prepared using polystyrene. Calcification was suppressed in the CNWs, SiC/CNWs, and SiC/Si scaffolds compared to polystyrene. Our results suggest that SiC-coated CNW scaffolds could suppress calcification and promote cell proliferation.

16 December 2025 in Journal of Applied Physics
Verified
Journal Article
Open access
AHAnna Honda
Anna Honda
MIMomoko Inayoshi
Momoko Inayoshi
NTNoriyuki Taoka
Noriyuki Taoka
WTWakana Takeuchi
Wakana Takeuchi
HWHirotaka Watanabe
Hirotaka Watanabe
YHYoshio Honda
Yoshio Honda
We investigated the electrical and deep-level electronic properties of carbon-doped GaN (GaN:C) crystals. Three GaN:C samples with carbon concentrations of 1 × 1017, 1 × 1018, and 1 × 1019 cm−3 were prepared by controlling the growth temperature in an autodoping process during metalorganic vapor-phase epitaxy. To evaluate these properties, current–voltage (I–V), capacitance–voltage (C–V), and optical deep-level transient spectroscopy (ODLTS) measurements were performed. The I–V curves exhibited diode-like behavior, with leakage current and ideality factor varying systematically with carbon concentration. Under light emitting diode illumination, a significant increase in capacitance was observed, particularly in the more heavily doped samples. ODLTS measurements revealed multiple trap-related peaks with activation energies ranging from 0.20 to 0.90 eV. These results indicate that carbon-related defects and their charge transition levels vary with doping concentration, demonstrating that the carbon autodoping method enables systematic control over deep-level electronic states in GaN.

21 March 2022 in Japanese Journal of Applied Physics
Verified
Journal Article
Closed access
WTWakana Takeuchi
Wakana Takeuchi
EKEiji Kagoshima
Eiji Kagoshima
KSKazushi Sumitani
Kazushi Sumitani
YIYasuhiko Imai
Yasuhiko Imai
SSShigehisa Shibayama
Shigehisa Shibayama
ONOsamu Nakatsuka
Osamu Nakatsuka
We investigated the local strain in a silicon carbide (4H-SiC) (0001) trench metal-oxide semiconductor field-effect transistor (MOSFET) using synchrotron nanobeam X-ray diffraction (nano-XRD) at the SPring-8 BL13XU beamline. Using X-rays incident on the 4H-SiC trench cross section, diffraction measurements were performed on the ( 11 2 ¯ 0 ) and ( 11 2 ¯ 4 ) planes. Intensity maps of the 11 2 ¯ 0 and 11 2 ¯ 4 diffractions yielded images reflecting the trench structure. The spatial resolution of the 4H-SiC 11 2 ¯ 4 intensity map in the [0001] direction was higher than that for the 11 2 ¯ 0 diffraction because the angle of incidence was close to perpendicular to the sample. From two-dimensional reciprocal space maps of the symmetric and asymmetric diffractions, the tilt and the ( 11 2 ¯ 0 ) - and (0004)-plane strain components were individually separated and visualized. A tensile strain of approximately 0.1% was found in the region between the trenches. These results indicate the effectiveness of nano-XRD for strain visualization in trench MOSFETs and similar electronic devices.

2 July 2026 in AppliedPhys
Verified
Journal Article
Open access
PDF file
WTWakana Takeuchi
Wakana Takeuchi
YTYuki Tsuchiizu
Yuki Tsuchiizu
KOKoki Ono
Koki Ono
KUKenichi Uehara
Kenichi Uehara
DODaisuke Ohori
Daisuke Ohori
Kazuhiko EndoKazuhiko Endo
Kazuhiko Endo
The formation of carbon nanostructures and silicon carbide (SiC) using a single-source precursor offers a simplified route for material synthesis; however, the factors governing the transition between CNT-like structure formation and SiC growth remain unclear. In this study, the growth behavior of carbon-related structures using vinylsilane was systematically investigated by hot-wall chemical vapor deposition (CVD) on various substrates, including Fe bulk substrates and Fe thin films on SiO2/Si. CNT-like structures were preferentially formed on Fe bulk substrates, whereas Fe thin-film substrates exhibited CNT-like growth at the initial stage followed by increased Si–C-related phase formation with increasing growth temperature and growth time. In contrast, on Fe thin films with limited catalyst amounts, CNT-like growth occurred initially, followed by increased Si–C-related phase formation with increasing growth temperature and growth time. These observations are consistent with a growth transition associated with the balance between Si uptake into the metal and surface SiC formation processes. By controlling catalyst amount, growth temperature, and growth time, the relative formation of CNT-like structures, SiC-rich coatings, and intermediate morphologies could be tuned within a single process. Furthermore, a SiC/CNT-like composite structure was directly formed on a conductive Fe substrate in a one-step CVD process. Electrochemical measurements showed an enhanced current response compared with a bare Fe substrate, indicating preliminary electrochemical activity and suggesting potential applicability as a high-surface-area electrode platform.

11 May 2026 in Journal of Applied Physics
Verified
Journal Article
Closed access
AHAnna Honda
Anna Honda
MIMomoko Inayoshi
Momoko Inayoshi
NTNoriyuki Taoka
Noriyuki Taoka
WTWakana Takeuchi
Wakana Takeuchi
TKTakeshi Kato
Takeshi Kato
YHYoshio Honda
Yoshio Honda
Carbon-doped GaN (GaN:C) is widely used as a semi-insulating buffer layer in GaN-based power devices. Although the electrical properties of GaN:C grown by carbon autodoping have been extensively studied, the influence of the carbon incorporation method remains unclear. In this study, we investigate whether the conventional assumption of discrete, quasi-isolated carbon-related deep levels remains sufficient to describe defect states when carbon is introduced via an external hydrocarbon source. GaN:C layers grown using C2H2 gas were characterized by current–voltage (I–V), capacitance–voltage (C–V), and optical deep-level transient spectroscopy (ODLTS). The samples exhibit a resistive and effectively fully depleted state at high carbon concentrations. ODLTS measurements reveal an evolution of trap responses from quasi-isolated states at ∼1017 cm−3 to broad and distributed responses at ∼1019 cm−3. These results indicate that the carbon incorporation pathway influences the nature of electrically active defect states. By comparing our results with previous reports on autodoped GaN:C, this study clarifies the distinct evolution of defect states induced by C2H2 doping. These findings provide insight into the realization of stable semi-insulating GaN buffer layers for power device applications.